you need the felt to swipe the knuckle ball. RTV alone won't do much good. Reuse the old ones if you absolutaly can't get new ones but they...
.....and vicious bump steer. JB
Dan, You're going to have to put it on about 1/4" thick to cover those welds you posted pictures of. JB
I would be quite concerned with only half thickness of mating surface on the TRE taper. I would watch them closely for wobble to start. They may...
put it in 1st gear and turn the output shaft 1 revolution while counting the number of turns of the input shaft. if it makes 4 revolutions it is a...
1. It bolts to the tcase using the same 5 bolt holes that the cover plate used. 2. yes, you can operate the tcase while pto is engaged. You can...
are you sure the spindle isn't slightly bent ?? JB
hmmmmmmmmm?? JB
what size intermediate shaft did it have ?? JB
Did you install the axles ? do they fit the side gears correctly ? Are you saying that when you put the jeep in gear the rear driveline turns but...
a little more info might help. JB
your springs need to be a little shorter or you need to move that hanger a half inch or so back. you have a geometry problem allowing the spring...
I wouldn't call a swap to a model 20 an "upgrade". Offset the 9 " or better yet upgrade an offset 44 with good full floater axles. JB
I guess I don't get your question then. If the jeep is where you want it, put the 373 gears and carrier in it. Doesn't really matter if the 488...
I am going to assume that your front driveline doesn't fit because it uses the small u-joints. If that is the case, take the front yoke off your...
converting that 2 piece tie rod to a solid tierod and drag link would be a great improvement. JB
The sm420 is smaller but you lose that advantage with the long adapter required and the big reverse hump. Floor board work is floor board work....
if it is not leaking out make sure your PVC valve is well sheilded and not sucking the oil directly into the intake and burning it. Plugs might...
if the carrier from the '70 uses 30 spline axles and you are going to keep 2 piece axles you are out of luck. I don't believe 30 spline tapered...
........you drink it................. JB
Separate names with a comma.