i just did an ebay search for "jeep hubcaps". lots came up, but this particular style was harder to find. not sure if that's because they are...
I came across these when going through some old parts. I think I picked them up many years ago at a tag sale. I never ran them on anything....
edit to my terminology above - i was thinking "cup" when saying "cone". i just always use "bearing" and "race". anyway, the bearings (cones) are...
so i have a spare carrier from a 30 spline flanged 44. i just measured the diameter where the bearing presses on and it is 1.800". the timken...
timken carrier bearing and race part numbers for my flanged 44 is 25590 and 25523, respectively. not sure about a tapered 44, but i imagine it is...
yes, not uncommon for the tube side (inner axle shaft) to be missing the slinger/shield. the inner shield is small and rots away in a lot if...
yeah, that's what i said earlier - i will probably talk to a machinist friend of mine and see about just having them made if my search continues...
yes, that is a possible route to go, but i prefer to keep my 11" drums and its just a ton more money that i could avoid spending if i could just...
Yes, I did read the thread - it was one of the first ones I came across when I began looking for this shield. There is talk of the shields being...
It seems to boil down to a drum brake vs disk brake issue. The smaller 1.875" ID of the 72-75 (drum brake) shield is a light press fit onto the...
I put together a side by side of both the 1972 and 1974 FSM's so that the differences can be seen. The inner axle shield was “part of” the axle...
Thank you for checking. The part that jpflat2a indicated was part of the axle assembly prior to 1974 (8126232, 9.368-9 in the drawing) is...
thanks for digging up the part number. I mentioned in my original post that the dana spicer 36364 outer axle slinger/shield has a ID of 2.125"...
ok, i think that's the difference. this odd ball shield i'm looking for appears to be specific to the '72-'75 dana 30. the 1976 and on shield is...
i've only come across this one. QU40324 Early 2" Outer Axle Shaft Slinger it is the only one i found that has the 1.875" ID and a 2" OD where...
thanks. the 8121398 jeep number is given above in the drawing. the trouble is that when i search for that part number, the few listings that...
I'm looking for the shields that press onto the axle shafts (both inner and outer) of a dana 30 out of a 1973 CJ5. Here is a picture from a FSM...
Thanks. This is a big help. Is that image from a FSM? What year? I see in the bottom left it calls out model M-54 and M-195. Based on a...
Sorry guys - another exploded view request that i can't seem to find when searching the internet.... My 1973 Dana 30 has a set of Warn premium...
thanks guys, yes the brakes are different - forgot about that. but sounds like the same axle (absent the shafts). i asked because i have a good...
Separate names with a comma.