Does anyone know of a good source / part number for a clutch alignment tool for a T14 - 225? I don't have an extra input shaft. Any ideas will...
Will the adapter on a two piece bell housing from a T86 bolt up to a T14 or will the adapter need to be replaced?
I assume this has been covered before, but I couldn't find it in a thread search. What mods are required for an ECJ5 ('71) conversion to YJ...
I have a 1971 CJ5 with a 225 and a T14. The transmission is out and over the years the bell housing has gotten lost. I've found one on the...
Sorry to bring this up again guys; I know there's been alot of threads on this (I've read them all). I had settled on buying a BDS 2.5" suspension...
Autozone has two clutch discs listed for my '71; one made by valuecraft and the other made by Duralast. Both are rebuilt. The Duralast is twice...
Does anyone know where I can get replacement ceramic tips for a gravity feed sandblaster?
I tried to remove the motorola 40 amp alternator from my '71 225 :v6: last night and the pivot bolt hits the radiator before its out enough to...
I'm making shackles and have the plates cut and drilled. I want to weld in a spacer. Does anyone know what the measurement should be or should I...
I've removed the AIR pump and associated plumbing on my '71 :v6: . What have other guys used to plug the holes in the exhaust manifolds? The...
I'm redoing my rear end and have to replace the pinion seal. The Chilton's says to measure the torque required to rotate the pinion and torque the...
Hello all, I'm new to this page which explains why I posted this message in the intermediates page first. I am currently rebuilding a '62 CJ5 and...
Hello all, I'm new to this page; it looks great. I am currently rebuilding a '62 CJ5 and have it down to the frame. The engine is on a stand and...
Separate names with a comma.