Thanks Guys. I'm giving myself an allowance of up to 1/2" but the perfectionist in me would like to see it under 1/4" we will see. If it were...
Thank JW. This information actually worked out perfect for me. With the info I was able to determine the hit side that I had straightened was...
Thanks to all the help thus far. One thing I left out is that it appears this tub was whacked once before and repaired by somebody with very...
I believe it should be. Somebody please correct me if I'm wrong.
Does anyone know the frt drivers side corner to rear passenger side corner and frt passenger corner to rear drivers corner measurements on a 72-75...
Thanks for the feedback gang. Good point on the front driveshaft. It gets very little action. I think I will just put both back in as they are...
I just rebuilt my T-14 about 8 months ago. Not a bad job but it has a few minor curveballs that you will need to think through. A press is very...
Hi, Curious to know how much work others have put into "rebuilding" their driveshafts. I am putting my 74 CJ5 back together and normally I would...
If it's an actual exhaust backfire (which sounds like a .30-30 blast) it will be either something electrical or valve related. If it is popping...
Thanks a lot for the responses guys. Despite my best efforts an incorrect throwout bearing thwarted my hopes to finishing the clutch Sunday...
I pulled out my pilot bushing and behind it was a piece of foam-like material stuffed in the cavity between the busing and crankshaft. Almost...
That engine looks great. Is it Seymour EN-66? I bought it on Amazon in rattle can for $11 a can.
Yeah that makes sense. I'll paint the long block and probably leave the 2 manifolds cast color. Eastwood has a great cast color in a spray can...
Which parts of the engine were painted the AMC blue from the factory on a 258? I know the intake, exhaust manifolds and water pump were cast...
Knipex all day. These and these will tear down most Jeep drivetrain components.
Yeah you really do need another tub to go off of and you will be referring to it ALOT. Other option is to ask us around here to grab measurements...
Glad you suggested that because I was considering doing that but was on the fence.
Yep that's what it turned out to be, it mushroomed a bit. Thanks Nick. Since it is only the last 1/4" and it's the part that sits in the end...
I am in the process of tearing down a Dana 20 on my 74 and I am having a bear of a time getting the shift rods separate from the case. I unbolted...
Thanks fellas. I figured that would be the answer. I gotta say the inside of the tcase looks really good just like the trans. This Jeep must...
Separate names with a comma.