The boot from A/A is for the short Buick bellhousing with the spacer block. Not for the longer 1 piece B/H. The hole in the 1 piece B/H is...
I just finished my `71. What I did first was adjust the internal shoes where they just touch the drum. The same way you'd do the wheels. then I...
After 4 long years and lots of help from you guys, I was able to drive out of the basement cave today. I appreciate all the help you guys have...
All you need is a small punch and a block of wood. There is a small hole on top of the rocker tip. The tip just pushes out. It's a press fit....
Thanks guys, I also need a shot of the drivers side beside the heater box where the e/brake comes thru. I have 3 holes on that side. One is...
Does anyone have a picture of a factory 1971 firewall layout. My firewall is 100% stock and I'd like to run everything back where it belong. I...
Does anyone have a source for the duct that run from the grill to the heater box on a 1971 CJ 5. It is apprtoximately 4.5 inches in dia.
I need a new gas pedal for the bracket that has the two ball sockets like the one pictured in MDmeltdown's post. Does anyone know where to buy one?
"Herm the Overdrive Guy" sells them with the correct valve for either disc /drum or drums front and rear.
http://www.eastwoodcompany.com has insulation material for heat shielding. I'v used some in the past with good results. The item # is 52142....
Are you guys looking for the 5 1/8 lens with 3 holes or the smaller ones with 2 holes. if you need the 3 hole I have a source for them and they...
The ring or spacer you're talking about is used to space the tag bracket out from the body to keep it from rubbing or being against the paint....
Help, Help I'm ready to install the rear gas tank, but don't have the three brackets that hold the tank to the rails. I have the factory...
Check out Eastwoods. They have lots of stuff for restoring and working on Jeeps or anything automotive.
Thanks guys, I now have a set on order.
Thanks guys, Any part #'s would be great Thanks
Does anyone know where I can find stock motor mounts for a 1971 CJ5 with a factory 225 V6 engine? The PO took the engine out and lost the...
Has anybody done the shackle reversal on their jeep or know of anyone that has? Was there any problems afterwards with the steering or possible...
Yes , the bracket will fit your V6. I got mine off of a mid `70's car along with the pump, hoses, belt (so I would know the right belt) and...
I'm restoring a 1971 V6/CJ5. I need the rubber boot that goes around the clutch fork in the stock bell housing to seal out the dirt and debris....
Separate names with a comma.