I was reading Sparky's comments in the buyer comment section and it gave me an idea I was told would not work. I want to put a late 70's early...
I'm gettign ready to start collecting parts for my next project "power steering". I think I'm going to go with Herm's conversion. Has anyone...
Fired up Jeep and took it for a drive. Ran great after setting about 6 months. Problem is clutch makes noise with petal on floor and the whine...
I bought a rebuilt transmission and overdrive and rebuilt my T-case. Went to put in overdrive and found I had a T-14 with a 26 tooth T-case....
How many teeth are on the gear on the back of the tranny in the t-case? I have a 26 tooth gear on a T-14. From everything I find my jeep is...
Anyone have a pick of the T/C linkage for a single stick D-18? I got the case in today and the linkage is not right.
What is the secret to shimming a t-case. I take out an .008 and add a .012 and it changes .003. I have used all but 3 of the shims in the shim...
Do you put any sealant on the shim stack? If you don't have a dial guadge is not checking backlash going to distroy my t-case? Also my...
Had my jeep for a while and I might get to drive it soon :) . Transmission and overdrive on it's way and after ordering heater core and waiting 6...
Old tires Just saw Super Swamper is making it's first tire again. They has 3 sizes and one fits a 16x6 rim. it is 30.2 " tall and 9.7" wide....
Where do you find a new bellcrank (or rebuild kit) for the :v6: :JEEP: ? All I can find is the 4cyl ones. Are they different? I want to...
The rear bearing drops into the case. Tight but not tight enought to stop it from seating on it's own when case is on end. It also slides on the...
The front bearing in the tranny looks like it was slipping on the input shaft. The book said it has to be pressed off but I was able to take it...
Took the tranny and transfer case apart today. On the tranny the front maindrive gear bearing had some play in it and the cluster gear is missing...
I took the 5 out for the first trip longer than a block today. The engine runs great (V-6 has some spunk) but I have a whine. It changes with...
Anyone got a Rockgear top? I bought one for my jeep and have had to re-fabracate the top door hinge to get the door to fit right. It uses the...
If I get the windshield frame acid dipped (to get the rust out of it) and powder coated will the powder coat cover the complete inside? If not I...
I'm looking to replace the sending unit in my 1970 CJ5 w/V-6. The tank is under the drivers seat. All the units I find list 1955 to 1967, and...
I'm looking for the dash light sockets for the alt. and oil idiot light in the speedo. The socket should have 2 wires (the one to the alt/oil...
I found a source for a new dash for my 1970 CJ-5. It has only the glove box all other holes need to be cut. If you need one Call Dennis at...
Separate names with a comma.