I'm assembling a 1986 CJ-7 that I purchased minus running gear and motor. I have two engine options available, all parts on hand so I can go...
I recently rebuilt my transmission and transfer case, along with pretty much everything else in my Jeep. I noticed a small puddle of gear oil in...
I finally bit the bullet and purchased a new vehicle, 2015 Ford Focus ST. I've been putting off purchasing a vehicle for quite some time. I...
Attempting to bench bleed the master cylinder, I just can't get the air out. Fittings and tubes are tight, but it continues to blow huge air...
I'm beyond mad at this point. I've broken 4 cables now, 1 of them being new. The free dash that came with the Jeep, is made out of 12ga steel. It...
So my custom braided stainless high pressure line for my power steering gear was leaking at the the gear fitting. I thought it was a bad fitting...
I hate all this electronic witchcraft....old Jeeps are much easier to diagnose and work on. My Cherokee died two weeks ago, it got me home but...
I just realized my 1980 tub tunnel opening has but chopped up by a previous owner. Even if it wasn't, my existing 79 cover to fit the T-150 / D-20...
I've read through earlier posts and found out adding a tailgate is possible however my question is, has anyone here actually done it? I started to...
Original 79 frame junked and replaced with an 80. Verified dimensions and length, same as original frame. My current issue is with the drive...
I'm putting my shifter back together and I'm trying to figure out if I'm missing something. The shifter diagram shows the interlock plunger being...
Are the smaller teeth on the mainshaft gear supposed to look like this? They are slightly beveled but not uniform which leads me to believe it is...
I was going to repair my tub however I'm looking at a giant ugly bright orange headache. The only salvage pieces are the cargo area, firewall,...
I just finished installing my front brakes and noticed the outboard brake pad rattles slightly. I can't find any mention anywhere of anti-rattle...
Opened up my front axle today for inspection, found a surprise. [IMG] Tried googleing the numbers but didn't come up with anything. Appears to...
I cleaned up and painted my leaf spring hangers for the front end yesterday. Today, I noticed the shackle bushings don't fit right. The lower...
I've been unable to get my frame un-twisted and my tub is in pretty poor shape. I happened across a pretty nice looking tub and frame off...
Before I tore the jeep down, I noticed the front left side was sitting lower than the other side. At the time, it looked like the stock leaf...
Earlier this year I sold a 52 M38A1 project I was working on and ended up with another Jeep. I initially located this gem on Craigslist however I...
Separate names with a comma.