Need to replace water pump on my v6. I know the 225 and the 231 pumps are a different length. One is about 3/4 to 1 inch longer. I need the...
I am seeking ideas on attaching a removal side bar on my roll cage. I have a full roll cage, down bars by dash and behind front seat. I am looking...
I need to replace my water pump, 231 oddfire,I have the short one now. Which pump is the shorter, 231 or the 225. Thanks
My front and rear springs are sagging bad. Need to be replaced. What options do I have, go back with stock springs or lifted? It is a basic daily...
Does anyone know if these are still being made by anyone? I have looked and could not find a source. Searched on this site and some members have...
Looked at some rims today, owner said they were Renegade aluminum slots. The front looks like the renegade rims I have seen. What markings are on...
Just got back from junkyard. Picked up a wiper motor and switch from a old postal jeep. The main wiring was gone. The wiper motor has 4 leads, a...
I have a sloppy saginaw steering box. Manual box not power. I can replace it with another, but, will the s-10 box work in its place? It seems like...
I put a 231 v6 in a flattie. I need to add exhaust pipes from exhaust manifold to mufflers. What size should I use, 1 1/2, 1 3/4, 2 in. What is...
I am installind a dana 20 in a flatfender. The dana 20 has a bracket on the passenger side by the shift rails. It has 2 threaded holes, what is...
Just picked up a dana 20 transfer case. Question that I have, the case mounts to the cross member with rubber mount and torque bar and stud. On...
Does anyone know if the 225 and a 231 odd fire v6 use the same harmonic balancer? I have a wanted ad in classifieds. Thanks.......
I am installing a hei in a 225. The hei has a o ring seal on the shaft. Does it require a gasket under the body of the distributor, between the...
Recently purchased 70 commando, 225 v6. The exhaust is gone. Is there a source for original y pipe? Also did all the commandos with the v6 have...
Are there different bellhousings for the 4.3? I have a T90 to adapt to 4.3. I have a Novak adapter for GMs, but holes do not line up in...
Re: Buick LH exhaust manifold swap question Not to Hijack question, but, does any 225 or 231 have y pipe exhaust running and exiting on drivers...
This is for any flatfenders that have put 225,231 in flatfender. I am using a monza crossflow radiator. What top radiator hose did you use? What...
How do you tell the difference between the low gear(6.32.1) and the (4.2.1) T18? The one I am looking has these markings. Case-- T18-1B Tag on...
Does anyone know where to look up part numbers for 225 v6 parts? I need part numbers for water pump pulley and crank pulley. Any help...
I am adding dual master cylinder.I have mid 70's disk front axle. I have master cylinder and bracket from early 70's vehicle. What I was...
Separate names with a comma.