Dear tcfeet: I went to a '66Dauntless X '58M38A1 conversion. My paint is Mil-Spec Viet Nam Era OD Green, the light green seen on the old CJ-5...
I need an oil cap. Having trouble finding one. Any suggestions? Thanks.
Where are the Pix?
I have a Jeep tee-shirt, got it online or somewhere, has my Jeep, only civilian, with steps. I don't see them often around here, and my paint...
I want to put a pusher inthe M38A1, since the V6 installation left the fan a bit too far back from the radiator. I don't figure on a temp switch,...
I went with Tank Renu. Kept original my original 50's underseat tank & senders. Lifetime warranty, less than 200, but a NOS underseat M38A1 is 400.
The plastic bearing in the original ross went south. Local Napa is ??? The bearing seems to be nylon, so I fgure it has been replaced at least...
You can probably delete this thread. Upon further examination, the hat channel welded to the interior rear tub has its own metal...
I am about to mount a '70s series jerry can carrier (nylon strap) to a '50s M38A1. The hole configurations are different, and the spacer pack is...
Watchout if you take the stuff apart, there are 2 sets of needle bearings stacked one on the other inside there somewhere, They aren't hard to...
I ground the pin of the transfercase shock, stubby or whatever it is called, off, the rubber is still there, with the bolt. I cut it off flush...
Could you just try driving it in reverse in 4H, stop, go to neutral and then try 4low? It is a muddin' thing when things get sticky, shake...
I am aligning a Dauntless/T-14 onto an M38A1 (F-4) frame. I have the engine, tranny and T-case on a picker, and the frame on jack stands....
Separate names with a comma.