Hope I'm not flogging a deceased equine, but I didn't find a thread dedicated to this. I'm looking for experiences and knowledge about powder...
I'm wanting to find out the name of the shade of white used on CJ5 wheels in the mid-50's. Wasn't a pure white, had a slightly "cream" tint to it....
Several years ago, I bought the Rick Stivers VHS tape on how to rebuild a T-90 transmission. Since I'm getting close to actually rebuilding it, I...
Does anybody know what these threaded holes are for in my frame? 1956 CJ5 frame, there's a pair of threaded holes on each side. I can't for the...
So, I'm formulating a plan to separate the engine, clutch, transmission, transfer case and park brake assemblies. Any tips on where to start, and...
So, is this thing supposed to be flat, or curved like this? I realize the front and rear edges are supposed to be angled, but what about the main...
After more years than I care to admit, I've finally got some of the parts assembled to somewhat resemble part of a Jeep. And I'm actually working...
Apparently when my hard drive smoked I lost some photos, I can't seem to find my photos of how my clutch and brake arms and all the associated...
So, I've got this 1972 D30 front axle to put in my '56 CJ5. All rebuilt and ready to hang, same with the original D44 rear. But I thought of...
OK, I'm almost ready to put my axles and springs on my frame, and I need to start developing a plan. What's the best/easiest/safest way to do...
Anybody have some good photos of how the stock brake lines are ran & attached on a '72-'75 Dana 30 front axle? I'd like to do my brake lines as...
Anybody ever use Speedi Sleeves to cover/repair worn seal areas on axle shafts, spindles, etc.? Just wondering how well they work.
The outer axle shafts on my '72 Dana 30 (the stubbies), they go through the spindle. Inside the spindle is a needle bearing. Near as I can tell,...
Does anybody have a nice exploded diagram/drawing of a '72-'75 vintage Dana 30 front axle? Just wanna make sure I understand where all the pieces...
OK, I'm trying to reassemble my D44 (finally!). I've got the seal, shaft, bearing and race installed on one side (left), and the race is quite a...
Here's the scenario...... Early D44 rear axle housing, bare naked, powerwashed and degreased, blasted and powdercoated, then degreased and...
I started this thread recently about replacing the axle shaft seals in my Dana 30 front axle....
So, I'm rebuilding this '72-'75 Dana 30 front axle to put in my '56. Going through all the new parts, I realized I hadn't bought any new axle...
I'm having a local guy setup the diff in my 1956 D44 rear end. He discovered that one of the bearings just fell off the carrier/case. Bearing...
Just like it says - what year did the Ross boxes change? I know the later ones were a different/better ratio than what my '56 is, but when was the...
Separate names with a comma.