Here is a write-up of my setup that cost me about $100. --> welder write-up link
I recommend stock YJ springs OVER the axles. You gain both lift and flex. Couple this setup with some RS9000 adjustable shocks and you get the...
After digesting Hudsonhawk's link along with this link (click here), I went with stock YJ springs over the axle which allowed for some good flex...
I used a 110 MIG w/ gas for just about everything and it did well. I had to be patient on the 1/4 stuff though. When it came to welding the new...
As Nickmil mentioned above, the outer casting ID may not be a true reflection of the 1st gear ratio as mine read T18-1B but was truly the 6.32:1...
I went with the J series shifter since the CJ series was worn out. I simply removed the shift extensions which allowed me to slide the shift box...
Nickmil can probably explain it better than I but since I have been down this same road I'll give it a shot. The outer snap ring on the bearing...
Dan - Sorry to hear about the mix up on the bearings. I was unable to locate my receipt for the wide bearing that I purchased from PartsMike.com...
Sorry - no experience with the low backs. I recently ordered a set of high backs with matching covers from jegs --> seat link. Should have them...
I'm running a body lift and sucked the tank upward to utilize the vacant few inches that would have been above the tank. In doing so, this left...
The master was mounted well above the steering column. I was more worried about it clearing the brake master. It did fit with about an inch to...
I used a Master/Slave and line from a '86 CJ7. If you want to stick with mechanical, I have all the stock parts from a '75 CJ that are in...
Is it possible that the valve cover or something else up top might be leaking and running down the back of the motor? I normally start from the...
Nice job on the shroud! I'm running dual Taurus fans and they do fine below 1500 RPM sitting still. If I wind it up above that while...
Missing pivot ball behind the clutch fork or possibly clutch plate installed backwards, or both?
Correction to the bur location from the quote above. The bur was on the input shaft where the seal rides and not the case (my memory of this...
I took the easy route and got all the hangers, anti-wrap perches and shackles from Partsmike.
I drove it home from the driveline shop and around the block a few times trying to troubleshoot the problem. In doing so, I found that the input...
I can't seem to locate the receipt at the moment from partsmike but I have it around somewhere. It's probably quicker to give Mike a call at...
I recently went SOA using stock YJ springs and the flex is awesome. To help combat body roll I went with the adjustable RS9000 shocks all the way...
Separate names with a comma.