does anyone know how or if I can convert a t90 colum shift into a floor shift? thanks, chris
I am going to buy a t-90A tranny to replace my T-90C tranny/ The shafts might be diffrent lenghts becse my t-90C is hooked up to a six cylinder....
I was looking to rebuild a t 90 tranny once i get one. If I do this can i rebuild it consisting of lower gears than factory. Factory is 2.98 or...
Hi I have a 68 cj5 with a 77 buick 231 motor in it. The tranny went and I am looking for a replacement. THe tranny was mated to a dana 18 transfer...
Hi I have a 68 cj5 with a 77 231 in it. I have the original tranny and transfer case from the original 4cylinder. I blew the cluster on my tranny....
Hi, I have seen the jeep. It is in by all the scrap metal and junk yards of rt 231. It is yellow with black top. I was so close to getting it,...
Hello I found some tank like treads for an 81 inch wheel base cj5. Has anyone ever heard or seen this. Does anyone have any information regarding...
thanks for everything guys i have learned alot
Yeah I am getting a new driveshaft for the front no matter what, so i do not have to angel the front to much. The rear is the issue. I did not...
thanks guys, Yeah I am prob going to get shims. I was just wondering if it was okay ot have the axle angled. I did not want to angle it and have...
I put a new lift on my jeep and was wondering about my axle. I had taken it off the car to clean it. After the lift the angle of the driveshaft...
I need to get some custom drive shafts. Does anyone recommend anybody else besides tom woods.
Yeah that would be great. Thanks so much
Where did you get your aluminum from and did you have to do anything special to mount it. I think that is the route i am going to take.
I have a 68 cj5 that started life as a 4 cyl. It has a 77 231 in the engine bay. It has been running about 215-230 degrees recently. The top of...
I had the shop heat it up and punch it on. It was directional and stayed on for a bit. When i got the new ring it fit very snug and did not move,...
Yeah thanks, that is what i was thinking
I have had problems with my flywheel. The ring continues to pop off. I punched it back on and it fell off once again. Brought it to a shop and the...
thanks guys, Actually the connection in the fuse box was loose. I checked everything and checked the fuse, however did not think to check the...
Hi everyone. I got in the jeep today to drive it down and get inspected. I started it and the starter just kept on spinning even when i turned the...
Separate names with a comma.