Brieoff, thanks for the post, the bracket for throttle return is a great idea. Where can I find the fuel filter that screws right into the...
Well, I've learned a lot about carburetors from this thread. I think what I'm going to do is stick with a hot air choke, according to what I read...
As usual Tim, you are right! The PO plugged the thermo part of the choke that came from the Wagoneer, and the choke cover on the 2100 was...
Thanks for all the help. I think I may have figured out the problem. The choke idle adjustment screw below the choke was screwed too far in and...
The original choke on the carb was a unit that connected to the manifold that had no electrical connection, and I replaced this with an electric...
I have a 1973 CJ5 with the original 304 AMC that was recently re-built. It has a MC 2100 carb with 1.08 mark on it and should have flow around...
Also, have you checked out Novaks website? It may be fairly inexpensive to rebuild your tranny vs swapping in something else?
Too bad you're so far away, I'm trying to get rid of a working T-15.
The Bestop " TrailMax" fixed rear bench.
Before I buy a new back seat for my 1973 CJ5, I was wondering if anyone knows if the new rear seat will bolt onto the original brackets? The...
My 1973 CJ5 has a D30 in front and a D44 rear. I am trying to decide on the best option for a rear locker for trails like the Rubicon. The...
Thanks Doc, My diffs are 3.73's, I forgot to put that in. I figure to change front and rear to 4.56's and add a Detroit locker in the rear,...
Mistake! I meant Dana 30 front axle.
I'm sure this is an old topic but new to me, so here goes; Sometime in the near future I'm going to go to lower gearing and a locker in the...
I got mine from a 1980 Jeep Wagoneer with a 360 engine when I converted my 1973 CJ5 to P/S. It fit perfectly.
The was a little piece in one of the latest JP Magazine articles about welding some tabs on the seat frame to make it work, but to save some time...
Hello, Everyone! I hope all is well with you. Various family and business obligations have kept me from my Jeep project for awhile, but I'm...
Jim, Thanks for the reply. Your post sent me right to the article I was looking for. Gary
I remember an article about how to give the driver's seat a couple more inches of leg room posted previously on this web site, but I can't seem to...
My vote; SM 420, one of the best tranny's out there.
Separate names with a comma.