I got to go ride for the first time saturday(never drove a 4x off road before). I had a blast and was very inpressed with the CJ5's capabilities....
I looked in my trusty vague Haynes manual trying to figure what is required to replace the rear axle seals on my 79 CJ5. Is a puller required...
I have a 79CJ5 304V8 that has been used and abused. I noticed yesterday the remnance of what apears to be a solid round brace between the motor...
Anyone tried these? Will the 34x10.5's fit on a 2.5" lifted 79CJ5 with stock body and shackle? How bad will they rub under full compression...
I have a 79CJ5 that is going to be off road "only". I want to weld the spiders, what type or # rod should I use. I want to weld the rear, and...
Just installed a 2.5" lift. My shocks are a little on the short side. Does any of the Auto Zone type stores have the shocks I need? What...
I just aquired a used set of 2.5" lift springs for my CJ5. There are more springs in the stack than my factory springs and probably need to get...
I have been searching here trying to educate myself about Jeeps. Great info guys. My Jeep is a 1979 CJ5, 304, not sure about trans(3 speed), it...
I just made a deal for a Jeep, I was told that it is a 1979 CJ5. When did they quit making the CJ5? It has a 304 V8, I was told. What...
Is there a specific model vehicle for doner seats for a CJ3B? Does anyone have experiance useing bench seats? Will (2) fit? What do...
Hey guyes, new to this great forum. Reading lots of good info here. I just purchased a 1953 CJ3B from a guy in the scraping buisiness. I...
Separate names with a comma.