some progress,, I think the wheel base will be from 104-108 [img] [img] [img] [img] [img] [img] [img] [img] [img] [img] [img] my...
im pretty sure it had the full float conversion, (dana 44) but ill look into it more, the m38a1 actually has a radiator on a hinge so it can be...
Re: enigine is in! but??? it was running fine the last time i started it, might just need some tweaking, did you use the carb i had on it? I know...
ok lost interest in this for a while and finally got back to it with all new plans.. (built an xj last year on 33's locked) [IMG] Ill get more...
If you want im sure i could call and find out the info. The schroon lake highway garage might have the info in their files.. Im pretty sure they...
must have the same ujoints front, its actually an m38-a1, also are the brakes a 9" or 10" on this, thanks Alex
for the interior iv seen some people use line-x, imo its way better then rino but it also costs more, napa also sells a bed liner product that...
finished it up tonight and mounted it:) [IMG] [IMG] [IMG] [IMG] [IMG] also does anyone know what size u-joints go in the rear...
yea, i think the later full floating axle would be the way to go, but they also cost more, i have to see what kind of axle is on my spare jeeps,...
ok, this is really wierd, when i put my t-case and tranny both in neutral i can reach down and spin the rear drive shaft :? ,,havnt pulled out the...
ok thanks, i can make 33's work,(they were free) now i have to get it trail ready, lots more work to do still, with the 33's ill just have to be...
i wasnt really asking what it could fit im more so asking what size tires the axles could handle without snapping, i had 33x10.5x15's on it but im...
does anyone know what size tires i could run on the stock drivetrain? also are there any lockers for the ten spline dana 44
thanks,
ok, i have a 1952 m38a1, i know i have a dana 44 in the rear but how many splines are there? i know theyre 5.38's, and also in the front i know i...
are they the stock ones or are they aftermaket lift ones? also will you sell them if they are lift ones, thanks
do you still have the leafs if so let me know.. the660noicemaker@yahoo.com thanks alex
also they should be 1 3/4" wide, or should i use a longer bolt and shim the shackles with washers to use wider springs
ok, i have a 1952 m38a1 with a shackle conversion done. im wondering what kind of leaf springs i should get and where i should get them, im...
just get a 2" ball for your truck,
Separate names with a comma.