I would like to get this if it is still available please.
Do you use the rubber end gaskets with the RTV or throw them out?
Due to a vacuum leak between the passenger side head and intake on my 225 oddfire I need to replace the intake gaskets. I bought the gasket kit...
Where did you find the 9 7/8" disc for this? Do you have a part number? Let us know how this works out, I have the same engine and tranny, but...
You will be fine, you just need to make sure that when you get your engine at TDC on cylinder #1 the rotor in the distributor will need to point...
So I think you have an odd fire shaft, odd fire pickups, odd fire cap but the aluminum casing I believe is an even fire casing, I had a similar...
The PO installed a foot parking brake which was much longer than the stock cable length and had that cable snaking everywhere under the jeep. I...
I would. The V8 in my truck made that sound right before a rod cap came off going down the road, somehow the bolt backed out a little bit and then...
If I understand you correctly I have a setup similar to yours, here are a couple pictures of mine. The hanging clutch pedal is connected to a...
That write-up was a huge help when fabricating my linkage. There is a wealth of knowledge in the Technical Library... In fact I use it more than...
Here is the clutch linkage I made for the Jeep, which is similar to the AA linkage: on my Jeep blog It was easy to do and is a huge improvement...
If it seems like it is having a hard time turning over then you may have a weak battery which would cause a weaker spark making it hard to start....
If I understand you correctly, when you let off the throttle it backfires, but runs fine idling and accelerating? My 225 with the HEI conversion...
Oil pan is where mine is located.
Clint, What did you end up doing to get the rotor to line up? I am having the same problem with a converted EF to OF HEI, the rotor doesn't seem...
Haha, no... It has been stuck on 75 since I have owned it, not sure if the PO broke it going downhill with a tailwind or it happened while being...
Here is the speedo in my 65: [ATTACH]
That is most likely a t18 but, it could be a t98, both had cases with that bulge in it for reverse gear right behind the PTO cover. It is most...
The weldernator was actually an easy afternoon project, it was a little intimidating at first since I had never opened an alternator before... The...
I made one for about $100 from a 94amp NAPA knock off of a Delco 12SI I won off of Ebay for $20. The rest of the money went to #2 welding cable, a...
Separate names with a comma.