I have not been on here for a while. The documents I submitted are informational and collected data with those inherent inaccuracies that may...
28150 Falls into the 1969 range of other titled units. Remember until the Feds mandated the year be part of the VIN number a lot of vehicles got...
SJT - Going on 31 years.
This is a Serial number list by production month but I did not have a complete list, so just the beginning of Jeepster Comando production. Added a...
Last time I posted these pic's was around 2008 and the thread no longer has the link so I'll post them up again. They made a bracket from steel...
Also make sure the MSD is getting a full 12 volts not going through the ballast resistor with the ignition switch on. BTDT
Since they started adding more ethanol to the fuel it seems to have aggravated this problem:shock: especially here in the dry hot country (west...
My 74 originally had a canvas loop with a buckle on it hanging on the windshield loop by the mirror for years before it fell off. Never used it as...
I've read somewhere, don't remember where that the engine was shifted 1" to the left for driveline clearance. As long as the output of the trans...
Good to hear you got it all lined out. Enjoy that Jeep.
Here is a link to my pictures on my 74 steering and brackets. Hope it helps. http://s853.photobucket.com/albums/ab92/dave74_photo/74CJ5/Steering/
This thread may help you. fuel gauge wiring | EarlyCJ5.com
I also have a 1985 4.3 with a factory 4bbl, but it was a non computer carburetor with no wiring present to indicate it was changed out (and it...
Is this the part? I've ordered parts from them before and had good service....
The Spicer BOM shows 27 spline only for the tapered 44 axle on the Jeepster delivered from 67 to 69.
The hook was designed so that the rod end did not have to come off the pin. Could change one pretty fast when I worked as a mechanic. Picked up my...
The screws I have on the CJ and the JC are #8 countersunk chrome plated sheetmetal screws, phillips head reduced diameter about 1 1/4" long. Hope...
Grote 44891 available at your local flaps should work for you.
The serial number list on Film Queens indicates Feb 67 production for your s/n if the list is accurate.
I just removed some from my partster, I used a pair of HF 90 degree snap ring plier as a spanner. Worked OK and did not seem to be close to...
Separate names with a comma.