Hi, all. I just got done rebuilding a T-176. Never haveing done so before, I'm glad that they're "easy" to rebuild, because this one...
I have a Motorcraft alternator w/external voltage regulator. When the Jeep is idling, the headlights have a timed "pulse" of dimming/brightening....
Hi. I'd like to replace the oil seal between the T-18/dana 20 while it's in the jeep, without removing the entire tranny/tc. Can anyone...
I'm going through a dana 30 front end ('78 or '79, not exactly sure), replacing seals, bearings, brake components, etc. It has 7/8' thick...
When I switched over from standard to power steering (about 2 years ago),I bought a complete used setup, including a steering shaft, from ebay....
-------------------------------------------------------------------------------- I have an AMC 20 rear axle, with 3.54 gears. I run 33"...
Hi. I'm cleaning up an AMC 360 to run in my jeep, until I can go through the "new" 401 I just bought. Anyway, I have looked up all the...
I decided to install an access cover a while back, when I had to change my fuel gauge sending unit. Dropping the tank, is no fun, so I decided...
I've posted a little more progress in my frame restoration.. starts at post #20... http://jeep-forums.4wd.com/showthread.php?t=36592
Hi. I was wondering about the featured jeep on the Home Page. I believe it belongs to Bill Livesay(?), at least that's what it looks like it says....
This thread is intended to help anyone who wants to have a tig setup at a relatively inexpensive cost. If you already have a buzz box, capable of...
I came up with this idea for an overflow tank. With a 1-piece tilt nose, it's impractical to mount one on the fenderwells. And there aren't many...
Hi, guys. Is there supposed to be an acceptable amount of endplay in a Dana 30 front axle shaft? I jacked up the drivers side of my jeep up...
I am in the process of replacing the seal on my Dana 20 front yoke. The nut was definitely on tight...I used a 3/4" drive breaker bar and pushed...
My jeep is supposed to have an overcenter spring on the clutch pedal arm. The p.o. apparently never installed one when they switched over to a...
When I swapped in a t-18 tranny, I lowered my tranny crossmember, and installed a double cardan joint rear driveshaft. I have to shim my rear...
Well, after finally getting my t-18 swap done, I just discovered another dilemma. The new clutch kit I originally installed during the swap...
Hi, all. I just finished installing a t-18 out of a FSJ pickup into my CJ5. When I installed the short input shaft, I examined all the...
Hi. I replaced all the rubber mounts on my jeep. I installed the transmission stabilizer stud the same way the old worn out one was installed....
I decided to go through a Dana 20 transfer case(new gaskets and seals) before I install it in my jeep. I bought a Rugged Ridge kit. I took off...
Separate names with a comma.