Does any one know if this one: http://www.jeepdoc.com/catalog/zproducts.asp?id=230 Third one from the bottom, will fit the frame rails of a '60...
How hard was it to get that engine into the bay? Did you have to move the firewall or extend the fenders or anything like that?:beer:
My books are in boxes either in the garage of the house I am in the middle of moving out of or the 4th bedroom in the house I am moving into that...
This part is listed for 41-64 MB, GPW CJ-2A, 3A, 3B, M38 but not for the M38A1 or the CJ5....
Will these heavy duty kits from KaiserWillys fit any 134 ci Willys four cylinder?...
Tried a search for this and did not turn up anything.R) I am in debate with myself about changing my mangled hood and front fenders from the...
Would it be possible to switch the D25/27 and D44 in an ECJ5 with those from a CJ7 with the turbo350/quadratrac setup? Or is that maybe a dumb...
I read on here that Dummy used retreads from TreadWright Inc. on Project:Hatari http://treadwright.com/ (used to be High Tec Retreading) Has any...
I was going through Herms catalog and saw a remote reservoir to be adapted to the original master cylinder cap. Sounds like a good idea. I was on...
During my reading on our wonderful objects of affection, I have run across references to 9 & 1/4 inch clutch disks as well as the 8 & 1/2 inch...
Does any one have any idea what the size of the crank pully nut is? I know that 36mm is slightly too big. (Air cooled VW rear axle nut size. I...
Any of you with the F-134, can you tell me what reading you get on a vacuum gauge with a warm engine at idle?? :? Mine runs a steady 6 in unless...
I'm getting the Pertronix 1548 for my IAY 4401B distributer. Right now I'm fighting with the points in there and they seem to be real touchy about...
I've looked in my books, both Chilton's and Hayne's, and also Moses Ludels' books for this. Is there some kind of padding or whatever in the...
How will the engine act if the condenser goes bad? Yesterday my F134 rain like a champ, the day before it was real ratty, like it couldn't make...
I was reading up on superchargers. Kaiser supercharged the 226 that was in their Manhattan sedan. Since this is the same engine that was in the...
Ok, pulled the underseat tank. Some of those bolts and nuts for the seat mount are real interesting to get to. Made me wish I had an extra length...
Where exactly should the frame VIN be located on a '60, and can it be seen with the tub and fenders mounted on the frame? Plus where else...
R) I did a search for locking gas caps and nothing came up. I probably didn't word it right or somethin'. On the underseat models, is there...
This might be a techie question, don't know. Will a ford 4spd from a 66 ford 2+2 work in a '60 CJ5", or is that shortening up the rear driveline...
Separate names with a comma.