I got my dana 30 back from the shop to replace my old dana25. It is from a 1980 cj7, and I know it has the 6 bolt caliper bracket and the thicker...
These kind (original I think) ground from the case/housing, correct? Trying to track down why one isn’t working. [img]
Looking for advice on how to replace my dana 25 mostly due to poor turning radius, and frankly I don't like having to baby it. I don't intend on...
I’m on an off-road trip and my passenger axle shaft must have a problem because the lock right is still powering driver tire but passenger has no...
I am looking for a place to start on steering issue before I start throwing parts at it. I have a saginaw power steering swap, a two-hole...
Swapping out my locking hubs for a a drive flange for first time after doing a herms kit. do I hammer down the dust cap flush with flange or just...
My Jeep came with this top when I bought it and I took it off after a few months since too hot in texas. With a Colorado trip coming up I figure I...
I am about to do the first start of my sniper efi, but the handheld keeps rebooting when I turn the key to start. At first I thought I had the...
I am looking at a used, but un-welded roll cage kit made by rhodes (they sell from different vendors like summit, etc). It seems to be for all...
Does anyone have experience with flat towing with the tow bar attached to the shackles? Currie Jeep Towbar System - Flat-Tow Your 4x4...
Does anyone have a solution? I've searched, but the closest I found was one that a member (for a bronco?) said was too large. I'm using the old...
This is all aftermarket stuff...I gave up on the original cluster a long time ago. I use a 15 gal MTS tank, an MTS sender and an autometer gas...
I did the sidekick disk brake conversion awhile back and I can’t get the passenger side to stop dragging. I thought it would sort itself out and...
Well I’ve been using this site for a long time, so guess I should do a build thread to help others not make the same mistakes I have and get help...
Here is my summary on the Rocky Road YJ spring lift, for those who might find it helpful. Again, thanks to those who did previous write-ups with...
i finally got my power steering hoses for my Saginaw swap. I filled up the pump tank, started it, and no power assist. So I gave it some gas and...
I finished my rocky road yj swap and Saginaw conversion and took it in for alignment. I went to a chain place and not my usual due to distance and...
I’m wrapping up a Saginaw power steering conversion and am stumped by the power steering hose. I bought one or two I thought might work but they...
I am stumbling through a saginaw swap and are to the point of replacing my driver's side manifold. I was able to get all the bolts out without...
Has any one put suspension seats for a sidexside/utv in your jeep? I'm looking at the low back version of Rhino Replacement Seat - PRP Seats....
Separate names with a comma.