OK, you put fresh gas in the tank. Is the gas making it to the intake when you work the throttle linkage? You say you have spark and the timing is...
Probably beep fluid. Sorry, couldn't resist.
For years, I didn't own a set of feeler gages. I had a spark plug gage a matchbook and my ear. That is how I was taught to set up an engine, so...
I don't see that as being a problem. It is pretty typical with mechanical gages. If you want to see a faster reading, switch to a sending unit and...
When I built the harness for my 62, I ran individual power leads to each gauge in the dash and grounded them all off a common ground. A variation...
You have to use a separate site, such as photobucket or similar.
I could be wrong but, 8305 designates it as a Universal and 165801 place the manufacture date as Nov.1963.
Nice Jeep and welcome from Ward, Arkansas.
What he said. Mine comes on at 200 though.
From reading this, I would look at the adjustment and return spring first. My thinking is the pedal is not returning completely.
I just replaced mine last year from O'Reilleys.
If I was to hazard a guess, I would suspect an electrical switch at the pedal. I have a dual master cylinder but only one switch. It is mounted to...
It is called a pitman arm. Try calling some vendors and asking about V6 specific parts. I found almost everything I needed so far by looking at...
I had the same problem. I used a straight edge and a 10 pound hammer. Now the backing plate is like it should be and it did not cost me anything...
This place has gages and the whole spedo if needed. http://www.cj-jeep.com/cj5-6/cj5-6_parts_and_accessories.htm
As a former LEO, if I thought I was in the right, These two would have earned a ticket. Police do not carry the law books around with them. If I...
Hope this will help Bill. http://img.photobucket.com/albums/v367/ExpressEN1/JEEP/100_0933.jpg
There are some in the technical section. Not sure what years they work on but they worked on my 62.
To find TDC, disconnect the battery, remove #1 plug, hold finger over the plug hole, rotate engine until you feel pressure building in the #1...
Guess I will go with bondo and fiberglass. I am hearing the same kind of things from people around here. Talked to a friends dad, he owns a body...
Separate names with a comma.