Well found the problem. Finally started thinking a little and went to the library and found a manual for a 73 jeep and found I had the brake power...
Resistance is good because the right hand side does work and flash and it is the same setup as the left. As for shorts, I can make all the...
Both rear lights are LEDs and the fronts are incandesents which is enough resistants to drive the flasher. I am tempted to buy a new turn/hazard...
I am finishing up wiring my 58 cj with a ez wiring harness and I have just one issue that I am not sure about. For some reason my left rear turn...
This does help. Not sure if I am going to put the fuse box inside a waterproof container or not. It is an idea I have bouncing around in my...
John, Very nice diagram! Way better computer talent than I have. :) If I am thinking correctly your diagram is wired using a duel element 1157...
Ok now I understand by running the ground circuit of the running lights thru the turn signal switch to where the turn signal switch is in a...
I thought the turn signal and running lights would be open when not in use. One side of the bulb is grounded to the frame and the other would be...
Never thought about running the 1157 with dual elements but that is what I will do. For some reason I had it stuck in my head that I needed to...
Picked up the ezwiring harness for my jeep last week and I am trying to decided on which route I should use to run the wires to the back of the...
I bought a top from Best Top and it does fit on my CJ6. I had to make sure the windshield to back measurement was correct. Mine was off a...
sorry double posted
Count me in for a CJ6. Mine is a 58 bought from the origional owner. My dad drove it when it was new and 40 years later we have it. Came from...
Since I have the earlier design with the hard brake line on the axle, I will order 2 rear brake lines to get the length needed. I looked at...
I need to buy extended brake lines for my 58 CJ 6 with a 4" rancho lift and having problems finding the right brake lines. The lines from...
Just a quick thought, what about using a later model jeep swing peddles. They can be found on craigslist or ebay easly. That is what I did for...
I know how you are feeling as I went thru the same thing with my 58 installing a v6. At first nothing seemed to fit and I was cussing up a storm....
Thanks for the info. I am getting excited to have the jeep running again. Still have to wire the jeep correctly, but for now I am going to do a...
Does it matter if the oil is GL5 or GL4? I have read other post saying GL5 isn't good for the brass bushings inside the tranny.
Well after a few years of wheeling and dealing and trading parts I am about to fire up the transplanted engine in my 1958 CJ6. I am installing a...
Separate names with a comma.