TA Performance lists 225V6 OF cap as TA_698A and the 231 OF cap as 698C. Any of you OF conversion aficionados tell me the diff or have a picture...
Rocker arm assembly is very cruddy so I want to take it apart and give it a good cleaning. The rocker arms move on the shaft but I can't get the...
The tub is a 66 Tux and the engine is 225V6 (correct era). The tranny/xfer that came with is T90A/D-18 twin stick for the 134 engine. The rear...
I am in the hospital flat on my back due to about 2 foot removAl of lower intestines since.Thursday. posi that note was to another poster. Write...
Couldn't find in search but would like to put T-15/D20 combo into a CJ6 using the stock output (center line) to the off-set D-44. Would the shaft...
Where would I find the difference between the bolt spread for the adapter where it bolts to the bell-housing. I need to know if the T-15 adapter...
I am trying to find the measurement from the back of the engine at the bell-housing flange out to the end of the crank shaft where the fly-wheel...
I have access to a Dauntless OEM T-14 bell-housing that is 9" deep and uses no adapter (direct bolt-up) so can I bolt a T-15 directly to this...
[IMG] Have searched a bunch with zero results. My knob is white and flat on the top. There is no indication of any shift pattern ever having...
[IMG] The bigger crack was about 1/4" total separation. [IMG] Crack repair was using JB Weld. About 6 hours after JB Weld was applied, I used...
Was thinking of doing the zerk install, but then I got to thinking. :D I don't have any areas close by to do any 4 wheeling so I don't know how I...
Background: FSM page 119 E-25 bottom of page. quote" The accelerator pump plunger has a vapor vent ball in its head. This ball and its...
[IMG] In the upper corners of the frame are three small holes each side. The upper hole is a bolt for the soft top brace bracket. What goes...
Not sure if this is the place for this? My research tells me that the soft tops for early cj5 cover 55 to 75 (correct?) I found a cheap top but...
Need help on soft top part # (no longer needed) Found a top for sale but can't tell what model it fits (from pic) and seller hasn't returned my...
Have been searching every place for that webbing that goes over the top of the grille. Have been looking for bunting -- hope that is what it's...
What manual trans/transfer did they use in the 71 jeepster? What I saw was not the T90. The transfer looked like a D-20 and had a PTO on it. The...
In pross of rebuilding my 2G. Took everything apart but I can't get the ball under the pump piston spring to come out. I have soaked it w/PB...
This hose is original on my 66 Tux and I was amazed to find the printing on it. "CRANKCASE VENT" and it's printed twice in white lettering but...
Before and After
Separate names with a comma.