I will take apic tomorrow afternon I have never had the dist. out so I will have to take it out.
see that the problem I can not get the timing adjusted to the 5 deg. point I have no more adjustment in the dist. I have tryed to advance the...
thanks for the support is there a topic on adjusting the points and the dwell I hate to sound stupid but I know very little about points and dwell...
ok at tdc the rotor is @1 1;30 put new plugs in and its running alot better but still sounds like it got and miss that comes and goes.
ok found the second slot and loosed it but still not running, moved the wires up one tower and adjusted the dist back the other way and it finally...
ok I will check this out moonday after I get home from work..... If this is the case would that be why I dont have any power ? And why the carb...
just looked and theres only one adjustment slot on the bottom of the dist. it has the oil port on the other side and one bolt boss on the other...
no but go out right now and look thanks
no I did not notice that wheres the other slot?
hey guys been awhile since I had the time to chat but been working on the 65- cj5 , I have the new solex carb on and seems to be ok but seems...
thank you SIDSCJ, for the link I will check it out. Yes, W3SRL, It does run great at first idle but with the choke off (all the way forward...
well been re-ringing the little f-head and got it all back together and started it up for the first time tonight had 40psi oil pressure and ran...
yes vent was open and even tried it with the fuller cap off?
had a friend of mine mic and he said that it was 020 over but the rings looked to be std. so now i am trying to find a set of rings for the f...
ok went back to shop and used a wire brush on the top off the piston that I had taken out earlier and this is what I found (1317P 020) Yes...
not really sure of the engine had been bore or not the compression rings looked like they had plenty of spring to them not sure about the oil rings.
no signs of any damage on the cylinder walls dont look like they put the cross hatch on the walls before they installed the pistons . As for the...
Ok pulled the head off, dropped the oil pan, and pulled out the #1 piston. there is no ring groove and the rings are free and loose but the...
well got every thing removed except the head bolts , I ll get those tonight.
glen I also thought about the oil pumping up in to the cylinders and causing this also?
Separate names with a comma.