You know I am not sure what year it was from. Not knowing the newer jeeps I had to look online at replacement parts to see what year it might be....
I have one, happens to be in a '68 as well. I replaced a worn out steering box with this one. Seems to be fine. What would you like to know?
I am a pretty poor mechanic so I am not sure how much help I will be but.... Make sure the basics are right first...ignition system is correct,...
The fuel pump is a dual action pump. The upper portion is the fuel pump and the lower portion is the vacuum pump. Sounds like you have that...
Greeting from a fellow transplanted Montanan to Phoenix
Well I looked at the t-18/d20 combo last night. The input shaft on the tranny is very long, PTO access on the drivers side of tranny, the transfer...
Thanks Timgr, sorry if I sounded curt in my last reply I was in a hurry. Thanks for the info. I hope to see it tonight
No sir. supposedly a t-18 tranny bolted to a dana model 20 transfer case. Not that I need another tranny.
Thanks Nickmil, I am sure I can find one here, I located about four at $100. I looked at one last night and the little support foot on the front...
I do remember that girdle from years ago....I had forgotten about it until you mentioned it. I found an article at jeepsunlimited that mentioned...
I've discussed welding it with a friend who has done some cast iron welding but I am going to try to stay away from it. I hope to find a 20 case...
Ok, I'm learning some things here. Thanks Niickmil. The transfer case came in a packaged deal. I bought a running duantless v6/sm420/novak...
Thanks guys for the quick responses. You’re confirming what I was thinking. Darn, thought I had something special with the big hole 18 case, hate...
I am a long time lurker and finally have a project of my own. I've gained a lot of knowlwdge here and appreciate the work that goes into it,...
Oldtime, straying from the 3B page! What would Derek say?:) I have the same measurement as Warloch on a '67 225, 22 3/4" from bellhousing...
mmmm, the last sentence of the original post he says,"I need info so I can get a body and get to work." I agree with Sparky, flatfender frame,...
So I went out and mocked-up a front fender on a 3b at a height that a 2a hood would put it at. It comes out at about the same level or slightly...
Yes actually I was thinking about it this morning. Great timing! I like the idea of getting a bigger tire in there without much lift. Open up the...
I am very sorry to hear about the loss of your wife. I lost my wife to cancer 5 years ago after 15 years of marriage. I'll always miss her but it...
If you have not changed the PCV system yet you can use what is present on your “new” engine. The open tube on your oil dipstick tube is the...
Separate names with a comma.