Its a fun project...while you're in there, consider converts from knuckle bolts to studs, there is a wealth of knowledge on this site for both the...
Is your shaft american made or over seas? There is a lot of variance in over seas made parts IMO, YMMV.
order one from krage $2.50, mght as well replace it with the real deal... :beer: www.jeepdoc.com/catalog/zproducts.asp?id=30 I'm sure he'll...
x2!!!
a wheel cylinder hone is sometimes called a brake cylinder hone, its just like a engine cylinder hone only smaller check it out, sears sells...
Update: Been in contact with Herm and he said that removal of the barrel nut will require a rebuild on the entire unit and the cost breakdown...
Hey Warloch, I take it you didnt damage anything else inside the OD using that square stock trick, did ya? I'd much rather get it out and send...
the snap ring and lock washer have been removed. to my understanding all that is left is the "barrel nut" which is stripped. it looks like...
that is the write-up I followed, but when I inserted the extension, it simply doesn't catch. therefore it's rounded (by the PO's dumb@$$.):mad:...
Here is what it looks like.
First a little background.... I scored enough parts (and cases) on craigslist to build 2 D18 and 3 T90 (for $40), the cases for the D18 are 1...
finished my rebuild today on my first t90! hooray! since this is my 1st auto rebuild attempt, i apologize that this question is so naive. i...
Fuggetaboutit = "Forget about it" You're good to leave it. :beer:
Any new parts that I have came from Border Parts here in San Diego. Thanks for the info on off-shore stuff being out of spec, I'll most curtainly...
That's what I would have expected...but not these, I even purchased a new sliding gear and that one doesn't fit either. I guess it's time to...
Hello all! Gathered up all the parts for my T90 builds (building a spare at the same time). My question is how easy is the sliding gear...
thanks for all the info!
Done searching online and hit up both Home Depot, Lowes and the local "mom and pop" hardware store and nobody carries these 1/2" flush mount pipe...
that is where I found it...
anybody tried this in their steering knuckles? says its SAE 250, might be a good alternative to knuckle puddin...
Separate names with a comma.