Anyone know the spline count for the output shaft on an early Commando t-400?
If you are interested in making more scoops I believe the AMC Rebel machine used the same scoop so there may be a market for a reproduction.
Does anybody know the offset for the later Renegade mag wheels? 72-78 vintage.
Are you sure those 27 spline diffs. are 44's? some 67 and 68 Jeepsters came with Dana 30 rear diffs. If it is a 30 check for a Powr-lok as this...
Can you think of any way to determine if this is for a 25 or 27? I don't have any 25 parts to compare at this time and have had no luck with the...
I am trying to ID a Powr loc # 23321X it is 10 spline and has 8 ring gear bolts. According to the tech page a 25 has 8 and a 27 has 10 bolts but I...
I finally got time to tear into the engine, .060 bore, Helicoils and broken head bolts. Manifolds are not Ford, Willys head, so far all that I see...
Does the starter bolt to the block or the bellhousing? If to the bellhousing I believe there was only 1 tooth count available, try a starter for a...
I don't really have a use for it, just trying to figure out if it is worth saving.
I have a GPW engine # GPW 172620, Casting code L11 311 AND gpw-6015 . Any information would be appriciated.:)
Thanks Guys!
Looking for information on swapping out a T-84 and installing a T-90, is it a direct swap or are there other parts needed?:?
The Axxxxx stamping seems to vary, possible date code? I have looked at several complete sets, the wheels being identical other than varying...
I know I've seen discussion on this carb. here somewhere but I can't seem to find it now. Is it a workable combination or poor throttle response?...
Pull the large bolt off of the housing to gain access to the relief spring and valve, clean out the bore and reassemble. My oil presure went away...
The catalog I recieved in the mail yesterday says 68-83 wiper nuts are the same.:)
I believe I have the correct seat brackets, send me your email adress and I will send pictures. Eric
Your problem is more likely in the oil pump and housing, TA performance has quite a few tech tips and products to deal with oiling issues in there...
Thanks:D
Anybody know if a 76 and later winshield frame will bolt on to a 75 and older tub?
Separate names with a comma.