Yes it’s on the bottom side in that picture and is grounded back to the block. I’m using that for the electric fan I have hooked up .
Ordered new GM power steering pump, waiting for it to come in.
Took everything off the intake manifold and took it to friends house who has blasting cabinet. Brought it home and chased all the threads and put...
I had been driving JEEP quite a bit and the power steering pump started making grinding noise. Looking closer I could move pulley 1/4” from side...
Timsresort has a good write up on drilling and tapping his steering box if you havnt seen it....
I bought a bottle the other day when I was in the parts store, gonna give it a try.
Maurywhurt, this is where I got the idea/information to go to the 7-blade. Thanks for the write up.
I verified this with my infrared thermonitor. My gauge is reading accurately.
Originally I was running stock water pump and it was running 10* warmer when I was running trails or around town in stop and go traffic. I...
Looking at where the fan sits inside the shroud it is inside it about an inch deeper then the outside lip. Thinking about trimming it back so the...
I pulled the radiator out and bolted the fan shroud to it. I’m thinking about cutting it up and extending it down and closing in the bottom.[ATTACH]
I have confirmed the temps with my hand held. I’ve considered that the build itself , with the higher compression, over size pistons, bigger cam...
[ATTACH] This was idling around levee in low gear after about 15-20 minutes. [ATTACH] kick on the electric fan…dropped temp about 5* in less then...
. 20 minutes idoling in drive way about 72* out [ATTACH]
Played with the JEEP today. [ATTACH] This was at an idol with no shroud. It’s drawing air through the radiator pretty good. [ATTACH] [ATTACH] ran...
Today was 81* out. Ran down freeway Between 60-70 mph temp was at 190* [ATTACH] pulled off the freeway and stopped at bottom of off ramp and it...
John, I have always wondered how much that shroud is doing with the bottom open. I went to the parts store today and picked up items needed to...
Thank you.
I was reading this thread and bought #J5357390. It will need the holes slotted about 1/8”. http://www.earlycj5.com/xf_cj5/index.php?threads/156120/
Heck, that’s just a case of beer from being done, it’s already a roller.
Separate names with a comma.