X6 (or 7 or whatever the count is at this point). I used an EZ Wiring harness, a little less expensize than Painless. Took a weekend of two...
Btw, good pic in post #1 here: http://www.earlycj5.com/xf_cj5/index.php?threads/140151/
Are you speaking of the blue coiled spring, or the gray pressed metal piece at the very bottom? And if the OP is refreshing original brakes,...
https://www.willysjeepparts.com/10_Wheel_Brake_Mechanism.htm Near the bottom of the page, part nos 945303 and 945304
That one on the left looks potentially useful in my case
Willys Jeep Parts should also have everything you need. i used them to redo my late 68. https://www.willysjeepparts.com/Brake_24.htm Page nav is...
OP here. Yesterday I finally got the rocker-arm-type hold down to actually prevent rotation of the distro. I had to jam a screwdriver against the...
Ditto. Didn't cost that much either, and wasn't too hard to do.
My motto is "never make the same mistake three times." I give myself extra leeway.
Thanks for all the replies, and sorry for not checking back in a few days. Yes, I have the rocker arm hold down. @Ollie2009, your mounting...
How big is that washer?
I wasted at least an hour trying to get the rocker-style clamp and bolt in and tightened the right way and never got it. It's in right now, but...
The round rail lights, even without screw-in lenses, had a couple of diameters in the 1960s. Some years ago I replaced my munged up '68 tail...
Is that a PTO shaft in the first pick in #23? Nice headers too.
Rear shaft may have been taken out for towing with a dolly, then just not put back on. Rear end sag may be because body mounts back there have...
Nobody's mentioned your wiring. Lots of threads on here about which new harness to get, and some say just repair what you have. I went with the...
The gas tank is right under your seat. If it were hot enough to boil, your *** would feel it. It's not boiling there. Whatever you're hearing...
You might want part # 119765 on this page: Air Cleaners
I think you want one of the # 945556 parts on this page: Brake Master Cylinders
Is it possible the recommendation for shielded / EMI/RFI suppression wires is for preventing interference in other devices (e.g. radio) and has...
Separate names with a comma.