Is it possible to remove the Ross box in an early 5, through the floor? In other words, it looks like with the trans tunnel / floor panels...
After several months of searching, I finally found a full set of baby moon hubcaps. The rears aren’t that difficult to find, but the fronts were...
For the life of me, I can’t find a nut to fit this WS washer nozzle. It’s 5/16” diameter, but it’s not the standard 18 or 24 thread pitch. It’s...
Next up on the to-do list is replacing my intake gasket. I have a substantial oil leak at the drivers rear corner and I assume it’s where the...
You guys might have seen my troubles with the water pump bolts on my V6. Long story short, I believe I would rather just replace my timing chain...
I’m going to be replacing my water pump this week. My question is - do you guys recommend any “dressing” of the gasket? If so, what kind? RTV?...
I know I just got back into an early CJ after a long hiatus. And I’m sure not trying to complain about every little thing, but why is the...
Can we talk about the front, driver’s side bolt on the Rochester 2G? It’s a COMPLETE pain in the rear to remove or install… Has anyone come up...
If anyone has a nice single-digit speedometer that they would be willing to part with, please let me know. The closer to 65K(ish) miles, the...
[ATTACH] I’m looking for the correct placement of the Warn locking hub sticker on the dash. I haven’t found many pictures of it on what I assume...
Can someone give me a measurement on the height of the center of their rollbar, off the wheel tubs? I think the bar in this Jeep is too low. The...
I’ve been able to find reproduction decals for everything except the embossed “JEEP” on the sides of the cowl. I’m pretty sure they were...
Does anyone have a part number or source for wheel studs for a ‘75 dana 30 with drum brakes? I’ve searched all the normal parts suppliers and I...
Does anyone have a part number for the studs to convert a set of Warn 10-spline hubs (Dana 25/27) from bolts? And in case they are different part...
http://greenville.craigslist.org/cto/3666221327.html Going to look at this tomorrow. I know early CJ's, but I'm not completely up to snuff on...
Can anyone identify this carrier? I've had it forever, and I can't remember what it came from. I suspect that it has to be a Dana 25, 27, or 30,...
I'm having a vapor lock problem. Drive the jeep for about 20 min and the electric pump stops working. Let it sit for about 20 min and it starts...
I think I might be missing part of my timing marks or something? Does this look right? [IMG] [IMG]
I thought a 10" brake set was a direct bolt-on replacement for the 9" brakes? I started my swap tonight and the top two holes in the backing...
I'm ashamed to ask this question, but this is my first 4-banger... Is this a Carter or aftermarket Solex carb? It seems to be running rich (fuel...
Separate names with a comma.