Yessir, the head is cast iron. I do believe it's around 1000 lb.
Picked up an air horn, fan, and two spin on style fuel filter heads. Bought a NOS pressure plate and v belt tensioner from ebay. I'll be tearing...
Yep I have a bell housing for it.
Well, here it is! [IMG] [IMG] Got the 3b involved to move the engine around. [IMG]
Well today I bought an aluminum block 3-53 Detroit 2 stroke and sm420 from a gamma goat for the 3b’s next great makeover. I’m thinking about a D18...
Thanks! I completely ripped off itlksez 3b for the most part and have slowly morphed it into how I want it, more or less. Buick V8 hei...
Probably the picture but anything is possible.
Wanted to go for a drive and brave the 45°F chill. Haven't driven down the road since I made the new driveshaft so I wasn't sure if it was going...
Back on the hunt.
I've never used the rubber packing on the rear main seals. Just filled the holes up with RTV and haven't had any problems.
Thank you sir! I’ve contacted the seller to try and figure out logistics.
After two months of being broken, I finally got the rear driveshaft parts and welded it up tonight. Modified the traction bar.... just imagine a...
I have that exact seal in two fheads. No leaks so far! Have you tried to torque the cap down without the seal and did it turn?
Hit the retainer with a hammer and try to compress the spring again. If you can find one for a decent price, a pneumatic valve spring compressor...
I ended up helping the guy pull the engine this afternoon. I remembered seeing some bell housings in a connex a few weeks ago so I walked up to...
Got the harness pulled this afternoon. I intend to integrate as much of the harness into the Jeep as possible like the headlights, blinkers, etc....
Dustless blasting is an option if you have someone nearby that offers that service. I have a HF pressure pot and it’s super slow as far as...
Axles have 3.54 gears. This works well for me since I want it to be more of road worthy Jeep for now. I plan to run around a 33" tire. It took...
I’m going to look again but I thought I saw engine mounts on the side of the block. Even if there aren’t it’s not a big deal. I bought the engine....
I found this at the junkyard. L67 Buick 3800. I'm seriously considering using this engine. It turned by hand and the oil looked fine. I'll see if...
Separate names with a comma.