Seems as though the previous owner of my newest acquisition thought a pipe fitting would work well in lieu of actual roller bearings and didn't...
Well, seeing as though a willys + car hauler is too heavy for a cherokee to tow I'm looking at flat towing my newest toy home. From looking over...
I swore to myself that I would never build another heep, but secretly wanted to build a Willys and was sorta looking for one every now and then......
Is there a part number for this terminal? I have the switch itself from another thread ~2 years ago (part #DR429), but am looking for the proper...
I know it's here somewhere, but was unable to find it... My head gasket has a small pinhole for the water passage. Is it recommended to keep...
I'm to the point where it's time to put the timing cover back on but the crankshaft looks like it needs a slinger on it under the timing cover....
I've got a long story that I can tell if anyone desperately wants to hear it, but it will end wuth the same question: When did the connecting...
I've finally got everything back togeher and on the road!! Except for one small problem that's making me a bit weary. Long story short, I found...
I just put together my 225 / 231 motor. (231 block, heads, and intake 225 crank, rods, and pistons). And low and behold, it smokes again!!! Now...
Just for a little background on this, I dropped an engine off about two months ago at a machine shop and was told that I'd have my engine in my...
Anyone know where to find one? I've been looking for about an hour now. My engine is at the machine shop right now and he's saying the one in...
Through talking with an aquaintance i was told that if i wanted to change cams from what is in there now to the comp cam (234-4) i would need to...
I've got a quote on what a machine shop wants to rebuild my motor (1200-1300) and i remember other quotes being in the range of 25-2600 for a...
I searched, I read, but I did not see where anyone mentioned where they got the Durabak other than the internet. I'm getting ready to put down...
Alright, I know I should know this, but I don't so I'm asking for a little bit of advice. I swapped in a supposedly good running engine in my cj...
alright, my cj bit the dust last night while driving it to a friends house to work on it. it seems as though the head gasket called it quits and...
i read the notice a couple of weeks ago and thought that i should have saved something, but couldn't come up with what that would have been. now...
evidently if you guys are rebuilding the l-head engine you need to pay really close attention to the bearings going back in. the oil passages...
i went through this when i first purchased tires, along with thinkin that i really didn't have the money for the ltb's at the time, and now i'm in...
okay guys, i finished my saginaw swap over the summer and everything is working perfectly on that front. I've got the original steering wheel and...
Separate names with a comma.