inlinetube.com and hydraulicstore.com have lots of brake fittings, hoses, tubing, etc. In steel or stainless steel. I used tubing & fittings...
I have a '69 CJ5 with a Dauntless V6. The starter used to grind once in a while and then it would catch after a few tries. Now the starter...
I had a problem like yours with a '69 CJ5 - hole punched thru the bottom of the case and my spider gears were destroyed. I found a parts jeep with...
My 69 CJ 5 has a piece of 12 ga. steel bent in a U shape that fits right between the wheel wells and is cut to fit the shape of the inside of the...
Thanks for the help. I got it out.
At this moment I am in the middle of trying to change the cam in my Dauntless 225. I cannot get the timing chain off so I can't pull the cam out....
Thanks for the info. I just ordered the HS8723PT-7 gasket set.
I am looking for Fel Pro head gaskets for my '69 CJ5 Dauntless. I found several head job gasket sets with the Fel Pro # HS8723PT-7. Supposedly...
I have a '69 CJ5 that we just put the motor, trans, etc. and crossmember back in last week. Both sides have two ΒΌ" thick steel shims between the...
Thanks for the input. It's a negative ground, and has now been on it's maiden voyage around the farm. The reason I was confused about the ground...
I have a '69 CJ5 with a 225 V6 in it. It was a gift that we took apart and did a trans rebuild, transfer case rebuild, new clutch, pr.plate,...
I'm curious as to the strength/effectiveness of a roll cage that is attached to the rear fender sheetmetal. I know that there is a mounting...
There's a spacer behind the gear on the T-14 trans for sure. I would check with Herm to find out what you need.
I have a '69 CJ5. I had posted before about the front diff. having a hole punched thru it. I just put an entire front diff. from another jeep...
It looks like you are moving too fast. Keep a fluid puddle and weave it slowly. If you weave to fast you will get undercut. You are mixing 3...
Maybe you should send it to Herm and get it done right.
I don't accept any package without inspecting it. If there is the slightest amount of damage to the outside of the package I open it and inspect...
Regarding the carb I would make sure I have a good inline filter and put Stabil in it if it were going to sit for a while - no matter which engine...
I have attached a picture of the trans with the bearing, etc. installed. I figured out the bearing orientation, but am not sure if I need a...
Back in January I asked some general questions on rebuilding my T14. I ordered all the rebuild parts and pulled it apart. Once it was apart i...
Separate names with a comma.