JP magazine did a tire review about 2 issues ago. I based that article on my new tire purchase--or vice versa. I orderd BFG Mud Terrains from...
I'd recommend putting in a comprehensive carb kit. If it is the original Rochester, it is not that hard to do. Take pictures and take your time...
I find no evidence that they were on my 67.
OK, I got it fixed. I ground on the hold down on the dist cap enough to get the movement I needed. Thanks to the information gleaned from...
Since I'm so simple when it comes to distributors--do I pull it out, rotate the oil pump drive shaft a little counterclockwise and stab it, the...
I am setting up the new HEI distributor on my 67 CJ5 with the 225 and I can't rotate the distributor CCW enough to keep the timing from being...
You can get a combo that fits in a 2" receiver, but it might not meet your load rating.
If it was me, I'd get an EZ wiring kit for $115 off ebay and rewire. I'm finishing installing one in my 67 CJ5. It is complete with all the...
The wire for the coil that bypasses the resistor is hooked-up to the S on the ignition switch. The positive from the alt goes direct to the...
Re: Help a girl out New Jepp Project My Dauntless has the pcv hose on the passenger's side valve cover hooked to the intake under the carb. On...
If I had more room I'd have more Jeeps and parts too.
Re: Help a girl out New Jepp Project I have the original oil-bath air cleaner for my 67 with a 225, but I wanted a typical chrome top with the...
Harbor freight runs coupons occasionally for a 20oz gravity gun for $10.00. You really ought to try one of those just for grins and see if you...
When I took mine to the machine shop in they used a hole saw the fit tightly around the stud and drilled a little into the outside face of the...
I bought new seat cushions for my 47 from Beachwood Canvas and they weren't but about half that I believe. It is not that hard to do the work...
On the 98 TJ I had, a 1.5" lift was enough to cause vibration and I had to use a Cardan driveshaft. What is important in my experience is the...
I had an original starter rebuilt for $130 by an electrical shop here in town. The flat spring thing broke after very little use. If I can get a...
I'm sure Walck's would have it if anybody did, but like he said it is easy to find a replacement locally--in most civilized places anyway. I...
My 67 came with an Autolite carburetor and an adapter by Mr. Gasket. Luckily, the Rochester was under the seat complete with the little aluminum...
Sta-Lube brand has a pump that fits on their jugs at least. I put a piece of clear tubing on mine so I can verify that the lube is flowing.
Separate names with a comma.