ok, so i power bled the system and now have much better brakes but still have to pump it to get real pressure. I am thinking that bench bleeding...
i should add that the shims between the axle and the springs are to re-align your pinion angle with the t-case, and do not as part of their design...
On my 78 Cj we cut the knuckles off of the ends of axle tubes, then rotated the knuckles back to their factory location. if you shim your axle to...
i would suggest you blew up a tie rod end, did these get replaced?
I have a dilema, i have no brakes unless i pump the system a couple of times. if i wait about 30 seconds, i have no pressure again. I have...
do not use sealer on your header gasket, try the graphite gaskets from felpro i think. The are awesome, about 1/4 thick
Separate names with a comma.