not sure what u did, but i have one.
If you havent passed this on yet MAKE SURE rebuilder understands how to leak proof it. info is on the website.
dont chuck ANYTHING.
Been working on a shroud for my cj5 V6. The one pictured is my prototype and made from 3/16 paneling glued and screwed. Hopefully I will refine...
JW60, How has this worked out for you?? The new baffle looks like a bear to bend. Do you have a water flow shut off valve so u can get freash cool...
I have resisted in the past, but I'm getting older and this was probably my last chance to try this. I'm rebuilding my T90 shift tower, putting...
Yes I ended up tearing the T90 tower down, detent ball springs were stretched by PO making shifting very hard. I took out the 2 to 3 shift fork...
Glenn, Not a big deal to me. What I found was loose pin installed to hold shift fork to shift rail allowing the fork to wiggle around. I sent my...
I'm going to contact him about it.
SILLY QUESTION, BUT I DIDN'T SEE IT MENTIONED. IS #1 PISTON ON COMPRESSION STRIOKE AT TDC??
OK, OK, I owe everyone an apology for the above post. I limited my T90 shift tower rebuild research to this forum only. I'm a little rusty in my...
I'm looking for a t90 shift tower rebuild guide. I'm looking for a t90 shift tower rebuild procedure. I have searched the forums but only found...
I did check out the t90 shift tower Herm sent me with with the rebuild t86 into a t90. The one i mention which seems to shift hard. question 1...
I'm finally back working on my jeep. I bought and installed a HERM rebuilt T90 transmission. My first question is that when shifting, the...
Yes I showed the shop the "evidence" and they agreed, gave me my money back for their work plus 20 and a new bushing. No hard feelings either, so...
I sent u a pm.
Finally Got the transmission stabbed this morning. Borrowed a trans jack and put a new pilot bushing in, took my time and it went nice and smooth,...
OLD TIME thanks for answering the question. That's what I needed.
Separate names with a comma.