Just got back from my maiden test drive. No leaks! :) I used Permatex Anaerobic gasket maker on the shims, and Permatex "Right Stuff" on the...
My leak came back slowly after driving the Heep a few times. I don't think the copper spray holds up well against gear oil. I called Permatex and...
I have some of that sealant but it is more of a brown color. This is what I have: Amazon.com: Permatex 80019 Aviation Form-A-Gasket No. 3...
Update - the t-case is slowly leaking through the shims again, which I thoroughly coated in Permatex copper spray before re-assembling. I can...
Well, the Quadrajet extended inlet fitting worked well. It was able to bite into the undamaged threads in the carb. I painted the threads on the...
Delo 400 XLE Synblend, 10W-30 Delo 400 XLE Synblend 10W-30 | Chevron Lubricants
Thank you for that. I found that site yesterday and ordered: 7/8"-20 x 1/2"-20 - .400" Thread Inlet Fitting It has more threads so it should...
The 55125 is the only one that is even close. So I ordered that part (Amazon Prime) and will see if it works. I have a feeling that it might be...
I do. I am confused if the fuel line itself is 5/16", is the threaded fitting on the line a universal size, i.e. 1/2"? The self-tapping kits I...
Cool, I "think" I need something something 7/8" on the big end and 1/2" for the fuel line fitting. Think this might work? Dorman 55125...
Well, I'm really stuck now. In the process of un-threading the larger fuel line fitting that threads into the side of the carb (the piece that the...
All great suggestions, thank you guys. I will try some of these ideas as soon as I get some spare time and check back in with the results.
Yes, I have a manual choke. The jeep starts just fine when driven the same day, and the choke seems to be functioning correctly. The carb is the...
Hello, I'm tackling the next issue on my '70 CJ5 225. It seems that if I have not driven the Jeep for a few days, it takes several rounds of...
Update: The yoke is leak free. Yeah! Stacking two 473229's on top of each other did the trick. The pan still does have the tiniest seep at the...
Wow, nice writeup! Looks like another project in my future as well...
Thanks for clarifying that. It sounds like I am in trouble then and need to try to remove and install a fresh outer bushing. I must have somehow...
Just an update, I installed some NOS sector shaft bushings today (M38a1 bushings!). I was able to carefully tap them into the housing using a...
Mine drips from the back of the oil pan a bit as well. I don't think it's bad enough to worry about yet.
Thanks for all of the input guys. I just re-sealed the transfer case oil pan with Permatex "The Right Stuff". I was very happy with how the...
Separate names with a comma.