I need to attach these V8 badges again to the painted tub. They are the originals and pretty heavy. Any suggestions or thoughts on what has...
I have the original 16” wheels for my Jeep (‘72) but no tires on them. I’d like to do something like the pic attached. What size(s) 16” tire...
‘72, manual steering The u-joint connecting my intermediate and steering column shafts has play and needs to be replaced. The TSM says this is...
‘72, 304 Went for a short drive around the block. Was the first time she’s been on the road in over 30 years. Felt great after this 5+ year...
I’ve bench bled the replacement MC until there were no more bubbles. I’ve replaced all the shoes, springs, and adjusted them to decent...
‘72. Pressed in the new ball joints and installed the knuckle. Upper ball joint went perfect. Torque to spec. I can’t seem to get the new...
I’m trying to replace the inner axle diff oil seals inside the diff on the front axle of my 1972 cj5 Dana 30 (at least I assume it is a D30,...
‘72. Anyone have a part number or option for the clips that retain the parking brake cable in the pic? Looks like I need three total and they...
When installing a drive shaft, does the shorter, sliding end connect to the differential or does it even matter? I may have mine in backwards.
My original gauge cluster is beyond saving. Not reading great things about the $100+ Aftermarket ones from Omix, etc. either. I think I found...
I’ve got a switch like the style attached. It has two positions as you pull it out. I wired it like the original one was, but who knows if that...
Anyone know if this one by Crown (J5350061) will work for my T15? Most websites say “76 and up” or “T18 and up” as usual. I like the studs on...
‘72 304 My replacement alternator is slightly different than than what was on the Jeep when I got it and want to make sure I’m connecting things...
I have the original, unique to ‘72 cj5 cable clutch set up (attached), not the factory modified manual linkage that they did later that year as a...
‘72 Is there anything special about the original 3 stud terminal block for the junction of the three headlamp wires on the firewall? I can’t...
‘72 304 (original wiring set up) I’m probably over thinking this but it is my first time doing under the hood wiring. I’ve read previous posts...
‘72. Manual, original drum brakes front and rear. So the rear re-do was no problem, went as expected with lines/fittings going out to the rear...
‘72, 304, MC 2100 I just want to make sure I have these two ports identified correctly as I hook up my 3-port CTO. Pretty sure port on...
‘72 cj5 Did some searching on the forum and couldn’t find a similar previous discussion. Sorry if this is a duplication. I’m replacing a brake...
‘72 304 Is this right? It’s the only way I could figure out how to reinstall the throttle cable due to it’s length. Seems to function right...
Separate names with a comma.