Thinking about that, you are correct. There will not be room to remove the side shift forks with the mainshaft still in-place.
Ken, that same style was used on the wagons and pickups of that era. Replacement parts are sort of unobtanium, especially the glass, and I...
Yep. Just plug the side "ports" and install the floor shifter. On a CJ5, you have a large enough floor plate that you can do that without...
Actually made from 66 through 71 so not that rare. I used a D20 case for this-$15 at the scrap yard. An added bonus is if you decide to install...
It's unquestionably a much better transmission than either the T90 or, especially, the T86AA. You can bore the small index D18 cases out to 4"...
It depends on the type of pump. Just about all the diaphragm pumps will allow fuel to be sucked through them. The gear pumps, not so much.
But how do we know if it's antique air and space? Smells ripe for fraud.
I think the original application of synthetic rope was for marine use where it very clearly has a BIG advantage over steel. Back in the 60's,...
When I originally did the frame-off build of my 3B I had the Bendix 11" brakes on it and those were set up as cutting brakes utilizing a couple of...
There are rear offset fans available with conventional blades that will move more air than that style. One can use a combination of various...
I have the same concerns. That will likely allow way more flex than you want, most especially if fan blades are close to either the frame of...
I have had perfect success using the doubled seals. If the old yoke just has the one groove in it from running the single seal, the doubles will...
There is absolutely no reason to use a V6 radiator if you can fit something larger-which will always be the case here. Aluminum? Absolutely with...
For Warn's, I don't think so.
Ahhh, the statistician. Part of my job at the U was looking at data sets from superfund sites (EPA contract) to see how tightly controlled they...
IME, a 327 with the 538 gears would burn rubber in 3 rd gear, not that I would have done anything like that---
Since the T86 is out and sans cover, is the first gear spiral cut or a spur gear? Is the main shaft spiral cut?
The other way of coming up with a "383", using all GM parts, is to use the 400 crank in the 350 block and the short 400 rods with 350 pistons....
Link to that site?????
The fan and shroud are clearly the most important items here. If you have a well fit shroud that doesn't allow air leaks between it and the...
Separate names with a comma.