Thanks. That would make sense. Just wanted to confirm I wasn’t missing something. Ill leave them alone.
I’m all for making work for oneself, but stitch welds are quicker :bananatool: .. On that note, not sure how you get ANY work done with the wife...
10.5 I’d “hammer to fit, file to clear” a 35, if 12.50 width was a requirement. Especially if it’s going to be aired down a majority of the time...
while I’ve had to tear down the transfercase, I’m thinking about spraying them with paint again, whilst apart. The transmission and transfer case...
Thanks for the diagrams Tim!
Looks like those are still hanging in there. Think I might pull one and compare to remanent ahcs. I spent a few hours on the Saturn bench years...
Tore the body apart on the Warn OD. It has the original brass fork with a drift pin in it. It shifts like it should. I can’t think of anywhere...
Thanks. I’ll double check for that fork cap screw. Didn’t notice it missing, but that’s because I assumed they used a set screw. :poo:
Lots of Jeep and buggy shops around you that are competent. I’d figure around $2K to build a cage in 1-5/8” or 1-3/4” DOM. If you are up for a...
That clutch release arm opening is pretty large in the bellhoising. I’d just disconnect the linkage and grab the release arm and make sure you...
The motion ratio shouldn’t have changed with the chain kit. The torque tube is a 1/1, so any difference in throw between pedal and arm should...
I removed the Warn OD from the Dana 18, it feels tight, looks great in the planetary area, however, I found a small amount of metal flakes caught...
Draglink are different. The dauntless runs a forward facing exhaust manifold on the driver side to clear the Ross box assembly. You might go to a...
Pull cluster gear and send it to Herm for the AA taper upgrade.
These peeked my interest after your review. Just heads up, these Y742S in the 7x15 are on clearance over on Tirerack. Yokohama only lists the...
Dewalt 20v series has a couple led lights and a 12v charger available. Plus you can run an impact gun for lug nuts, etc. Amp/hr of battery, would...
Depending on drill press, you could use a cheap mill hold down set. Can find them for $60 +/-
Maybe “agree” wasn’t the right term. As a fellow automotive numbskull, I understand your expectations while simultaneously understanding their...
Gentleman, we should start a new thread in off topic where we argue for 400 pages about SOP, QC, tolerances, etc and then we start our own company...
yes, I agree.... at what expense though. There are thousands of these bearing, hardware, etc type component parts (with specified tolerance)...
Separate names with a comma.