Had a hairy road experience on Saturday. I was driving the jeep for a few local errands into town. On the way back, doing about 63 on a slight...
While looking for information on checking gear oil levels with the D18/T14 I came across this on the CJ2A site. Very interesting and I sure don't...
Pulled the plugs to spin the crank and noticed the even side bank is blacker. In the past they have always been the desired tan color all around....
I'm putting a hydraulic clutch in my '68 225/T14/D18. I pulled the trans/t-case this weekend. The bellhousing stayed on so I can setup the clutch....
No, I guess you could say this is an upgrade to the upgrade. It's been twelve years since I busted my knuckle at Truckhaven and documented the...
I have a pair of new races to install in a pair of new front Dana 27 wheel hubs. Can I put the hubs in the oven and races in the freezer or will...
I'm changing to a hydro clutch in my '68 225/T14. I've not yet found the right slave cylinder. The clutch master is 3/4" bore from Speedway. I can...
In the picture below is a power booster I bought as part of a brake upgrade I'm doing on my '68. To the rear of the diaphragm is a bracket and...
I need a good flare tool for 3/16 brake lines. I'm frustrated by all the junk out there. I have a K-D Tools flare kit. The one with the two big...
I am collecting parts and working on the design of a disc/drum upgrade to my CJ5. Knowing that the internet is rife with mis-information I am...
Like a lot of older jeeps my tub has lots of holes. Too many. So many that on one wet trip my camping gear was getting muddy from mud getting in...
At some point between 1968 and 1972 the rear wheel cylinders went from 13/16" to 15/16". Are these interchangeable? My rear 10" x 2" Bendix...
Since this will be a "project" I figured I'd may as well chronicle it here. I have a 1968 CJ5 with a Dauntless V6 and existing Saginaw steering...
I'm in the process of determining the details of a new exhaust system and am looking for some guidance. I have decided to use Novak block hugger...
My Hedman fenderwell headers have reached the end. Actually they where there quite a while ago. Between the last three trips I've had to remove...
Some time ago while noticing that my V6 water pump pulley had two grooves, one of which was not used, I thought about adding a second fan belt. I...
I'd gotten tried of welding and re-welding frame cracks at the very rear end of my '68 frame rails. A lot of you know what I'm talking about. If...
My good friend finally bought a jeep. 1972 CJ5 w/ a 304. Has a new Edelbrock carb and manifold. He'd like to upgrade the ignition as well. I've...
It's been an on-going project for about a month or so. Rebuilt the T-14 & D18. They were the only parts left I hadn't been through with my own...
This doesn't seem right. What is wrong with the mounting? The large rubber donut dosen't touch the crossmember. Do I even have the right parts?...
Separate names with a comma.