Thanks! I meant between 6 (spindle) and 9 (knuckle); sorry for that. I dont think its actually leaking from the lower bearing cap but there is a...
Looks to me like its coming from somewhere between the hub and the spindle. The top bearing cap is clean but the bottom has evidence of oil being...
Trying to figure out where my leak is stemming from and it kind of looks like between #7 and 9 from the first diagram in post 2. Any ideas what...
Here is a picture from the Roxor website. It's in the red circle. I figure it would be on the driver side frame rail? Don't know for sure -...
Just in case anyone is wanting to use the brake master cylinder & booster setup and has front discs and rear drums, there is one additional part...
Does the Roxor's brake master cylinder need a proportioning valve or is it built into the master cylinder? I currently have the brake lines...
This is what I was thinking... I'll give that a shot.
Anyone here know what thread size the brake master cylinder has? 3/16 is just a bit too loose. Can't get a good gauge with my taps.
Does anyone have any experience with the Omix-Ada stock replacement fuel tank? I've tried multiple fittings for the fuel line fitting but 1/4 is...
You would think but it didn't... Here's the link: Crown Automotive Weatherstripping Seals J0978995
It's got 3 channels in it. One on top, bottom, and center. Should I be looking for something else? Windshield is at the glass company getting a...
Anyone know the size of windshield lace? I have a new gasket but it didn't come with the locking lace...
I did get lucky. If you're going to do it, get the sheriff inspection before you start turning the wrenches.
To be honest, if I did it again, I'd start the title process before doing any work. I was sweating bullets. They really didn't ask any questions...
Thanks all. Jeff, I can easily move the passenger fender down to create more room there. Appreciate all the help!
Spent time adjusting tonight. The pics above in the driver's side is roughly a 1" gap. With some fenageling, I got it to just about 3/8" with the...
Thanks. Did you tighten up the fenders to the body or keep those loose too?
Separate names with a comma.