Very good. Thanks Mike
Is there a difference between the Dauntless Ross steering box and the F and L head jeep (older) Ross steering box?? If yes--what is the...
I just unpacked a new reproduction top wiper windshield from Walck's!!! It has a Taiwan sticker on it. When I slid the hinge in--huge problem!...
Gentlemen this has been an interesting discussion. I have never run a vehicle with an oil bath but I think we all agree that an oil bath serves...
M38 Something to think about. Thank you. Mike
Rick your thoughts are accurate. It has to put a very tight bend in the accordion hose--I would guess at 180 degrees almost. I am mad that I did...
Thanks gentlemen. I know Oil baths served the entire auto industry for many years. I like the look of the oil bath, also. I just did not know...
Thanks guys. When I bleed wheel cylinders, I put a line on the nipple that goes into container with fresh brake fluid--Same idea I think. When...
Frame up rebuild with all new brake system. Drums, shoes, wheel cylinders, lines, and master cylinder. Moved on to installing new body. I plan on...
Thanks for your response jeepstar. I was thinking all that you have shared. I actually have 4 oil baths. I am toying with gutting one out and...
Trying to mount oil bath in the '55-'69 CJ5 reproduction tub. Problem! The firewall in the reproduction is not true to form. It can be done, but...
PeteL--Thank you for the 10 seconds of your time. This diagram is perfect and actually it shows the rod on the fender side of the bell crank. I...
This forum is number one! I am clear on how it should look due to the replies. Most of the rod was there. I just welded a 4" section of 1/4"...
Tried to search forum to no avail. Could a member post a pic of the gas pedal linkage from firewall to the bell crank on the value adjustment...
That is what I thought. Thanks Howard
I have read a thread concerning the importance of this cable. I need a picture of how it attaches to the engine. (or bell housing). I have the...
Thanks for the info. This is the first cj5 project for me and it was disassembled down to bear frame. I also have six sets of seat to try and...
I am building this '55 and I am trying to figure out what is stock and then the next generation of seat frames. Seat frames up to '68 used springs...
I figured it was an example. I am getting ready to drill mounting holes in new tub "front to rear" and this post gave me pause. I know---who I am...
I am newbie---but is that pic really a '62 CJ5?
Separate names with a comma.