The best way to diagnose is too make the angle measurements, then you'll know for sure. Tom Woods site is one of the best as brought up earlier....
I squished my fingers in and measured my fingers with a caliper. I got 1.3". My engine is tilted down 6 degrees in the back. This is also an MD...
I just installed power steering in my 74 with the stock column, so I had to count mine. My steering shaft out of the column 3/4" 36 spline. A tip...
Check the rear of the valve cover. Mine has a slow leak and I swear it looks just like a rear main leak. Many years ago I had a customer with a...
Thanks jeepdaddy2000. I never liked that air filter and have been looking at the 5 1/8" air cleaner adapter and that should take care of my...
Thanks for the replies. Ohiowrangler, do you oil yours? When the filter was new there was no sign of oil on the filter or any instructions to do...
Does anyone know how to clean these little filters? It's a gauze element on a Welder 38 and what I understand is washable. I've searched and no...
I need to clarify my last post. I didn't weld a washer in the fitting, I put a small freeze plug in the manifold and and tightened the fitting...
[ATTACH] [ATTACH]
I just pulled mine out and measured it. I get 22mm, 1.5 thread. Although the 18 per inch thread pitch gauge fit better. My memory is poor. When I...
Another thought, you could just put a flat metal round piece (like a electrical box knock out) in the hole and tighten the fitting against it. If...
The 258 uses a different way of getting exhaust through the intake than the 304. The 258 uses a tube from the exhaust to the intake. It has been a...
Comes out to be 4.2 liters. This is a good site for stroker combinations. https://www.jeepstrokers.com/forum/viewtopic.php?t=3083.
To add my 2 cents. I'm running a 232 bored .040 over, Comp cams High Energy 260 cam, Later model 258 intake and exhaust manifold fitted with a...
I should also have mentioned that my brackets are not threaded, the hole in the frame was 5/16" fine thread. The factory bolts looked self tapping...
I just reinstalled my gas tank a couple of months ago and mine weren't self tappers. I'm pretty sure they are 5/16" SAE (fine thread bolts).
I just resealed mine. I used 3M Strip Caulk. Some good stuff, stays pliable but seals very well. https://www.napaonline.com/en/p/MMM08578
Jeeps leak to mark their territory, or it's a way for you to find your way back if lost.
Thanks, I need to go out and look at my options. Anything that would help straighten my leg a little more.
I'll see what my wife has. Seriously I'm thinking a heel rest in front of the accelerator pedal that would raise my leg up and closer to the...
Separate names with a comma.