Mods if you think this should be in general discussion, please move. I have been asked by several members to post up my NOS Warn 5687 install....
Do any of you old timers that had a Whitco or Kayline soft top remember if this Kayline soft top bow storage cover would be the same or close to...
For those of you with a mid to late 70 through 71 CJ5 with the V6. After almost a year of working with Jon Waldron at Waldron's Exhaust, we...
Apparently my search skills are either lacking or no one here has done a write up on a slider restoration. If you know of one, can you point me in...
Hey everyone. Information needed as fast as possible... The exhaust on my 1 owner 71 is still intact from the factory (second and third pic...
I am trying to figure out exactly what fuel filter was used on these two years back in the day. The fuel filter clamp has a 2.0"ID when snugged...
I am looking for the length of the eye bolt and the inner diameter of the eye. I know someone here still has a Whitco top. I believe the eye...
Another one of those "Jeep" conundrums. I have a Feb and Mar 71 both with double sided V6 badges, my friend has a Mar 71 with pins. My 69 and 70...
I know that there is another thread on this here, however it is 10 years old and there was no resolution. I am hoping that someone here still has...
I found this list on the CJ2A page. I have searched to no avail (perhaps I am using the wrong keywords). Do we have anything like this for the...
The correct shocks for my CJ are Heavy Duty Monroe 1-3/16". Fronts pn# 921896 and Rear pn# 921897. I went to Monroe's website and it gives me a...
Probably asked hundreds of times. Is there a chart anywhere that shows just exactly what on a Jeep came painted from the factory and its color?...
This is a scanned pdf of the original instruction booklet that came with my unopened DANA27 POWR-LOK Putting it up here in case someone wants to...
Does anyone here remember what color the original oem shocks were pre-72. Specifically 71 if you know. I have purchased the 1 3/16" Monroe's...
This will be a shout out to Herm the Overdrive Guy. Anyone on the fence about having your stuff rebuilt by Herm..... Just do it. I sent my...
This is the absolute closest I can get to the oem 3/8" wide whitewall G70-15 Load Range B Belted Custom Wide Tread Polyglas Goodyear. See pics...
I had my Renegade Ammeter restored by MOMA Manufacturing, a company known for concourse level restorations in Albuquerque NM. They did an amazing...
My Mar of 71 currently has the bell crank clutch setup. It also has the outrigger on the outside of the frame aft of the clutch pedal for the...
The PO had put on headers and I am going back to stock. What size and thread are the V6 Dauntless exhaust manifold bolts for the oem manifolds...
Hoping that this information will be helpful to anyone using these in the future. BE ADVISED TO NOT TORQUE OVER 25 FT LBS This is my NOS...
Separate names with a comma.