Free diff spreader. I made it when I was rebuilding my CJ5. No longer need it. [ATTACH]
I am (still) looking for an early CJ glove box lid button. Any suggestion of an alternative will work. Thanks!
Does anyone knows where to find the intake manifold gasket for the carburetor on an F134 and solex carb? Thanks!
Hi, I need to rebuild my carburetor and it looks to me like a Solex. I have been looking for a rebuild kit and all I can find is Omix. I have had...
Is this the correct position for the gas pedal linkage? It hits against the valve cover and when actuated touches the underside of the spark plug...
Does anyone knows where can I find the snap-in fasteners that go on the windshield frame to attach the soft top? I just need two. Thanks!
Hi, I want to replace my windshield latch since it does not catch much and I already had it drop the windshield frame on my hood on a trial drive....
What is a good top mount windshield wiper motor for a 62 CJ5? I would like something with more than 90 degrees. Thanks!
I have this reproduction windshield frame I am about to mount after I get the glass installed and there are a lot of holes that were not on the...
Does anyone know where to find the rubber bumper (or stops) that goes on the rear legs at the base of the CJ5 seats? Thanks!
Can anyone post the height on the seats from the floor, not from the tank for a 62 CJ5? I am looking to fit junkyard seats and I can move them...
While fighting the gauge demons (grounding, replacing the voltage regulator with a 5vdc source, all kinds of fun!) I discovered something not...
I am about to mount the roll bar on the jeep and I would like some advice. Should I mount it straight to the metal or is there anything working as...
I am finishing the wiring and I followed the instructions found here, I believe. The wire from the alternator that goes through the pilot light is...
Does anyone knows the size of the nuts that attaches the speedometer to the dash on a 62 cj5? I do not want to strip them and it is too tight of a...
I am looking for a source or part number for the connector that goes on this temp sensor. Thanks! [ATTACH]
Does anyone puts any type of sealer tape around the edges of the panels that go over the transmission and tunnel? I guess that would reduce noise...
This is the heater box that came with the Jeep. I works but all the vent covers are manual, so no actuator of any kind. Question one: should I...
Any ideas on what to use to keep the hood up, like the rod most cars have? I plan to fabricate one but if there is a donor from which I can "copy...
This is probably one of the dumbest questions ever posted here but I am trying to fire up the engine and I want to be sure I am doing it right. I...
Separate names with a comma.