I've had my share of problems. Oil line Fire, the worst(all burnt wiring repaired except fuel gauge wires),727, pan leaks,(mopar gasket...
62, built over 100 engines, first fire! Oil gauges used to come with copper line. To save 1.25$ they now come with poly line. I spent extra time...
Removed my grab hdl to die black to match dash. 3lb, heat sync thing with several tiny wires fell down. What is this? Can't find in my wiring...
Will a 2500 flash, 2100 stall, still pull away from stop at low rpm(1000)or less? 450-500hpish, 401, pulls Hard from 2-2500rpm-6000rpm , 727, 3:55...
My 82 j10 has never had signal lights that worked? I had the tilt column out, (bad slop in bearings), for rebuild. It had no signal light harness,...
I crashed my hot rod, gremlin x, 550 hp 401. Putting the 401 in my 82 j10. Gotta have 3in exhaust! My long tube headmans exit so close to frame...
My 82 j10, has a Giant heater box and fan on the pas side under hood. Headers and plug change and VC removal are $%&#รท. Would like to rip it all...
This shinny new 80$ carb came in! Looks good except for squirt pump adjustment! But how do you mount a air cleaner? Not OEM, but chrome 8in clamp...
Just started this from one day to next? Idle was so bad, I had to turn up 2 turns just to run? Air screw has little effect. It actually causes a...
Crashed my 401 gremlin,(500HPish) built 20 years ago. Engine going in my J10 pickup. Teck has changed a lot since build. I'm replacing my offey...
Crashed my 401 gremlin. Thinking bout 401 in J10? Don't wang to start breaking crap? Opinions? Comments?
The wheel in my j10 had slop for ever. The upper bearing finally came out. Time to attack. Need help with disassembly. Looking for instructions...
Just gotta vent! Watching my Friday mavtv gearhead shows today, and could have shot the tv? Owner describing his Cherokee, says it has thpe...
This thing sat almost a year with an exploded ballencer. Finally got around to repair, and working out all other bugs! Last night after VC gasket...
Lights got out of line, so I went to adjust? All 4 are broken (Too much rough riding). I have the stock rectangle outside lights, then I installed...
81, J10, 360, 727. The range linkage between tunnel and bucket seat, travel almost 180 degrees ? Should be closer to 90 degrees! Won't positively...
Son ask to use PATCH, to pull a huge case tractor with baller, out of road, into my yard till they could repair? Now the 134 runs fairly well, but...
[ATTACH] My 70 cj5 master cylinder was replaced during frame off repair build bout 3-4 years ago! Brakes work great, great pedal travel , only 1in...
The tires now bite pretty good. In mud both wheeles dig. But on rock, if one tire gets in some mud or something slick, sometimes only 1 wheel...
Had a nerve wrecking ride yesterday. While checking fences my upper coupler comes apart. It's an AMC column, but they bought them from GM. Later...
Separate names with a comma.