Hello Everybody, Had a little time today, and decided to print up some hood rests for my windshield...the print quality is low, I decided to do...
Just venting on this one....Yesterday I installed a pertonix ignitor kit on my CJ, and went smooth, no issues...unitil you close the hood, and...
Hello everybody, I picked up a nice rear seat dirt cheap for my cj5, but it’s tan, not black. I’ve been looking for a cheap seat cover and can’t...
Hello everyone, my cj5 came with a non working electric wiper, just drivers side, and I’m looking to replace it with either a manual or electric...
Im finishing up my front axle, and the wheel studs are practically falling right out of the wheel hub. I went and picked up new wheel studs and...
I have a 64 cj5 with small front u joints for the driveshaft. I bought the truck without the drive shaft installed, are the ujoints held in by...
Here is my 64 CJ5 with 302 I picked up a few weeks back. It has a 1980 ford 302, with a t86 trans case with t90 guts, D18 transfer case, Dana 25...
hello everybody, While I’m waiting on a new clutch kit and clutch release fork and before I start fabbing up new motor mounts I would like to...
I have a 1965 CJ5 with a ford 302 mated to a t86 transmssion and it looks like the PO did a number on the clutch bellcrank setup. As you can see...
I picked up a 64 CJ5 and it had some hacked up front crossmember to mount the steering bellcrank support and most likely to fit the 302. So here...
Separate names with a comma.