If at first you don't succeed... Weld on another... Or drill a thousand 1/2" holes by hand in 1/2"plate. step out the frame holes for bushings and...
We need to put that in the tech index. Needs some sort of pto speed output for the driveshafts and after the pto box.
I guess the question to the group is if we know how proud those nubs are from the surface? Because I would grind the nubs away and replace them....
I think he needs the treadle picture. It's on one of fireball's builds... maybe the blue one.
You just need a section of pipe to act as a collar around the bolt. And you only need it on the clips in front of the axles... or is it behind...
What are you using? do you like em? Where did you buy em?
Tinkered on the glove box today, got the TBI harness passed through without pulling the box out and re-drilling but I really should have taken it...
It should force the cross shaft all the way up the ramp and then eventually overpower the clutch pack. I don't think it is good practice with a 19...
I'ld use the m38a1 lever for a single non cutting brake arrangement, the others have a frustrating adjustment to get right for them to lock. If...
The real question is where are the oil collectors?
Is that a 500lb ratchet strap... That's really sketchy.
As for noise level, I think you need to brush the rust off the gears and put the sawdust in. Here's mine, you can here the gears on the little...
I used toothpaste. Worked on my head lights, worked on my head, worked on the rollbar paint that rubbed into my soft-top.
I pulled the rev/mile spec for the tire and went from there, because it reflects the squat in the tire at max load and pressure. That should be...
On my TBI system they included two wires that I need to connect to switches. One is the typical 12v Air conditioning up-idle and the other is a...
I think it would be a good size but that backlash.... some machines are an easy fix, others are not. The Southbend I borrow is a bit too small...
The engine being used, vehicle weight, and lockers, are also significant factors on crawl ratio needs. Open diffs don't typically have the...
It's really complicated. But in short... A long stroke gives a longer lever for the rod to push. But there is a given speed for the explosion...
I had a short list written on the back of my hand today as I left for lunch: Grind the 1/2" extra off the steering shaft. -done Look at the air...
Separate names with a comma.