A little back story first. Last fall I tore into my L head to do a valve job. Replaced all 8 valves my engine had been overhauled in the 90’s...
Here’s a picture with the frame it’s in
It has a frame for I think a CJ5 and the original remotes. I have one DC200R with a frame and roller fairlead and I have a Ramsey DP-1 pto &...
Could anyone tell me what a Ramsey model DC200R723 winch is worth?
Yes, after looking at this it looks like the larger thrust washer tab broke off at some point and was spinning. The surface is flat and I think...
Definitely have some in the morning. It’s 10 degrees outside and the case is in my truck.
Front lower surface of the case where the thrust washer runs on counter shaft. The face of the case of where the thrust washer rides. It’s...
I’m in the middle of a T90 rebuild and I just got the case back from being cleaned and after further inspection the lower surface where the...
There are several factors that are going to dictate the length of the drag link. Pitman arm length, steering box location, offset spacers from...
It’s my uncles shop we used that lift to make it a little quicker. Extremely handy to have around.
[ATTACH] Finally got started this weekend on my frame swap, oil leak repair and overdrive install. Here’s a couple pictures from last weekend. My...
Thanks guys I actually just got one located and it’s being shipped
Thanks for the tip. I’m new here and appreciate all direction and input
Anyone on here have a 2 hole steering knuckle that will fit a Dana 25? Gathering parts for a steering conversion. Thanks
Separate names with a comma.